Shadow II Options | American DJ specs

SHADOWII™OPERATINGINSTRUCTIONSCONT.

on the remote for desired length of time. The button is spring loaded, so fog will only emit for as long as you are depressing the output but- ton. It may take up to 30 seconds for fog output during initial start- up. If fog does not come out, after holding the button down the red button for 30 seconds, check the fluid tank and hose to make sure there is fluid going through the hose. If fluid is not traveling through the system try one more 30 second burst. Do not continue to push the remote output button as this may severely damage your unit. If fluid still seems not to be traveling through the system unplug your unit and return it to your dealer for inspection.

The unit must maintain a specific operating temperature to emit fog, when it drops below this temperature it must reheat. When the Shadow II™ reheats to its proper operating temperature, the red L.E.D. on the remote will glow. You will not be able to emit fog when the unit is reheating. The reheat process usually takes about a minute, when the red L.E.D on the remote turn off you will be able to emit fog.

SHADOWII™PREVENTATIVEMAINTENANCE

TO HELP PREVENT YOUR FOGGER FROM CLOGGING, WE RECOMMEND USING AMERICAN DJ® CLEAN MACHINE™ LIQ- UID. UNDER NORMAL USAGE USE CLEAN MACHINE AS NOR- MAL MAINTENANCE ONCE A MONTH. CLEAN MACHINE IS ALSO RECOMMENDED BEFORE STORING YOUR FOGGER FOR MORE THAN ONE (1) WEEK. ITS LIKE A TUNE UP FOR YOUR FOG MACHINE! CLEAN MACHINE REMOVES PARTICLE BUILD UP IN THE HEATER AND PROLONGS THE LIFE OF THE FOG MACHINE. CLEAN MACHINE IS AVAILABLE IN GALLON OR QUART BOTTLES FROM YOUR LOCAL AMERICAN DJ® DEALER AND MAY BE USED IN ALL WATER BASED FOG MACHINES.

SHADOWII™SERVICE&TROUBLESHOOTING

If you experience low output, pump noise, or no output at all, dis- connect the units main power immediately. Check the fluid level, the external fuse, remote connection, and be sure the units plugged in properly . If everything checks out and the unit still fails to operate

SHADOWII™SERVICE&TROUBLESHOOTING

correctly, the unit may require service. Do not continue to push the remote output button as this may severely damage your unit. Return the machine to your authorized American DJ® dealer.

If you are unable to return your unit to an authorized dealer you may return your unit directly to American DJ® . All returned service items whether under warranty or not, must be freight pre-paid and accompany an Return Authorization (R.A.) number. If the unit is being returned for a warranty repair you must provide a proof of purchase invoice.

Occasionally the fogger will spurt output from it’s nozzle, this is normal. This is caused by excess fluid building up in the heater exchange until it has to be released. The fogger will usually spurt fluid after large blast, but may spurt at any time. A fogger may even spurt out fog for a few minutes after it has been powered down.

SHADOWII™OPTIONS

F-Timer/SH3: Wired timer remote control

The F-Timer/SH3 is a wired, timer remote control that allows you three (3) different

operating modes.

•You may set your unit to fog at an adjustable interval and an adjustable blast duration.

•You may also set your unit to fog in a continuous output pattern. Pressing

the continuous button on the remote will blast the fog at its maximum level until the heater must recycle. Then the fogger will once again blast the fog output at its maximum level. The remote will continue

this operating mode until the continuous function is turned off. While in continuous blast mode be sure that you keep the fluid reservoir full of fog juice.

• This remote also has a manual control function that allows you to