Precautions:
1.Never operate unit when case is open.
2.Never cover unit as this may block air vents and cause overheating and possible fire hazard.
3.Never operate unit in the rain or in damp moist conditions as this could cause electric shock.
4.Follow standard electrical safety precautions when installing, operating or servicing the unit to prevent electrical shock, fire, or equipment damage.
5.Make sure head and yoke rotate freely
6.These units are for commercial use and contain no
7.Refer servicing to an authorized American DJ service center.
Make sure to clean the fan
openings, air channels and fan gratings regularly.
Getting
Started
Inspection
Every Mighty Scan™ has been thoroughly tested and lamped before leaving the factory. Carefully unpack the fixture and inspect the unit for damage that may have occurred during shipping.
Projector Installation
1.After removing the Mighty Scan™ from the shipping container, remove the hanging brackets knobs that have been inserted in the styrofoam packing material. The knobs are used to hold the fixtures’ angle. Without the knobs the weight of fixture will not allow the unit to hold your desired operating angle.
2.This unit can be hung or placed in any safe, secure position.
3.To securely mount the fixture to truss, be sure to use a minimum 35Kg rated clamp and always try to use a safety cable when ever possible.
4.Try not to mount the fixture too close to walls or other fixtures, this will allow for proper cooling.
5.Connect the IEC power cord into the top of the unit (See diagram 10).
6.Set the dip switches according to your desired operation mode [See Operation Mode on pages three (3), four (4), and five (5)].
7.Plug the power cord into a properly grounded electrical socket. Do not attempt to brake off or
8.After plugging the unit in, the lamp will ignite and the unit will reset to the home position making a clicking noises and returning the mirror to center home position.
Lens Focusing
1.Hang the fixture in your final desired position.
2.If no controller is being used,
A.Set dip switch ten (10) to the on position (See diagram 2).
B.Turn the sensitivity to minimum position (See diagram 4).
C.Plug the fixture in. The unit’s shutter will open and the mirror will reset to the center.
3.If a controller is being used,
A.Plug the fixture in.
B.Use your controller to set the fixture’s mirror in a center home position.
C.Open the shutter and select a gobo.
4.Adjust lens by turning it in a clockwise and
*Check that the voltage marked on the back of the unit is correct for your area.
American DJ Supply® www.americandj.com MIGHTY SCAN™ User Instructions page 2