Your first fixture will not have anything connected to the male XLR input connector and the last fixture will not have any thing connected the female XLR output connector.
5.During DMX operation the Mighty Scan will use 6 DMX channels to operate properly;
CH1: Pan, CH2: Tilt, CH3: Pan & Tilt Speed, CH4: Color, CH5: Gobo, CH6: Shutter
6.For all other DMX operation, please refer to the instruction that were included with your controller.
7.We recommend using a 10k resitor terminator for cable runs of more than 100ft.
•You must select the proper
•Follow the settings on the top of the The MIGHTY SCAN™
•On The Following pages you will see the approximate values required to control the various functions of The MIGHTY SCAN™
Servicing
Lamp Replacement
1.Disconnect the unit’s main power supply.
2.Unscrew the thumb screw on the front of unit and remove the cover.
3.Gently pull out the lamp/socket assembly.
4.Remove the socket from the lamp by gently pulling out the bulb from the socket. Always hold the socket from the base of the unit and not the wires. When pulling out the bulb it is best to hold it from the base and not the reflector end.
5.Replace the lamp and carefully replace the lamp/socket assembly.
6 Replace the cover and thumb screw.
Fuse Replacement
1.Disconnect the unit’s main power supply.
2.Remove the IEC cord from the socket (See Diagram 7).
3.With a flat head screw driver, insert the head of the screwdriver in the socket and gently prop up the fuse holder.
4.Remove the old fuse and replace with a new one.
5.Replace the fuse holder and reconnect main power.
Caution: Always remember to replace with the exact same type lamp and fuse, unless otherwise instructed by an authorized American DJ service technician.
Due not attempt to open or service this unit there are no user serviceable parts inside.
For repairs or service please contact your nearest American DJ dealer.
© American DJ® Los Angeles, CA 90058 USA The MIGHTY SCAN™ User Instructions page 5