3.SETUP
AC Power
This product uses a
To determine the power requirements for a particular fixture, see the label affixed to the back plate of the fixture or refer to the fixture’s specifications chart. A fixture’s listed current rating indicates its average current draw under normal conditions.
Always connect this product to a protected circuit (circuit breaker or fuse), making sure that it has an appropriate electrical ground to avoid the risk of electrocution or fire.
Never connect this product to a rheostat (variable resistor) or dimmer circuit, even if the rheostat or dimmer channel serves only as a 0 to 100% switch.
Resetting the Breaker
This product is equipped with a resettable circuit breaker on the power input circuit.
In the event that the breaker trips, the power will be cut to the entire product. Please see the instructions below for resetting this breaker.
1.Remove the power cord from mains power.
2.Allow unit to cool for 15 minutes.
3.After 15 minutes, you may attempt to reset the breaker by pressing the button with your index finger.
4.Plug the fixture power cord into the power outlet and continue recommended use.
In the event that the breaker will not reset (the breaker button will not remain inserted), contact CHAUVET® immediately, as this indicates a possible internal malfunction.
Page 6 of 16 | Arena™ Hazer 3 User Manual (Rev. 02) |