INPUTS AND OUTPUTS (Rear)
Aside from the headphone output and microphone jacks, all connections are on the rear of the VRM10.
A Mains plug with fuse and voltage selector.
Changing the fuse: The lid for the housing of both fuses can easily be opened by pressing both sides of the lid simulta- neously. After changing the fuses, please make sure the lid is closed securely. To switch the voltage selector it is also necessary to open the fuse housing. You must now twist the plug to the desired voltage setting. The selected volt- age can be seen from outside. Make sure to replace the fuses with the necessary value, as indicated on the back of the mixer.
**MAINS PLUG MUST BE UNPLUGGED TO SELECT THE VOLTAGE**
BLINE INPUT for channel 4
CLINE INPUT for channel 4
DLINE INPUT for channel 3
ELINE INPUT for channel 3
FLINE INPUT for channel 2
GLINE INPUT for channel 2
HLINE INPUT for channel 1
ILINE INPUT for channel 1
LINE inputs 1 and 2 are for connecting devices with an out- put of up to +20dBu (i.e. CD, MD, DAT, etc...)
JPHONO INPUT for channel 4
KPHONO INPUT for channel 3
LPHONO INPUT for channel 2
MPHONO INPUT for channel 1
The PHONO inputs are for use with turntables with mag- netic systems. They can perform best with levels form up to
N AUX
The auxiliary channel can be used for various applications such as:
-Recording of individual or selection of various channels
-Monitoring of an individual or various channels
-Additional effect send for one or more channels (when using an “empty” channel)
The volume can be set to 0dBu maximum and is controlled in each channel individually with the AUX (25) control knob. The signal for the auxiliary send is taken after the GAIN sig- nal path, but before the EQ section (please also see the block diagram).
OEFFECT SEND
PEFFECT RETURN
When using an external effects processor (such as the Stanton DJF1 professional DJ filter) you must connect the EFFECT SEND to the input of your processor and the EFFECT RETURN to the output of your effects unit. The input and output volumes can be at a maximum of 0dBu. The volume can be set and controlled via the settings of AUX SEND (47) and RETURN (48). The effect patch goes through the
The 1/4” Jacks for EFFECT SEND, EFFECT RETURN and AUX are set as follows:
TIP: LEFT
RING: RIGHT
SHAFT: GROUND
Q GROUND connection for turntable
If the connected turntable has a separate GROUND cable, it must be connected with the screw Q to prevent ground humming.
ROutput attenuation selector for MASTER 1
SMASTER 1 LEFT
TMASTER 2 RIGHT
The main output MASTER 1 is equipped with balanced (symmetrical) XLR jacks. The value of this output can be selected either at +6 or 0dBu with the switch R. The value of the output signal can also be individually set with the MASTER (51) control.
The XLR’s are set as follows:
1:GND
2:+SIGNAL
3:
1