Booth, Master, Digital Output | Stanton VRM-10 specs

U BOOTH

The output value of the BOOTH is set at 0dBu. It can be adjusted via the control knob BOOTH (49)

NOTE : BOOTH output is not affected by any balance/pan setting (50).

V MASTER 2

The output MASTER 2 is identical to MASTER 1. It has an output impedance of +6dBu, which can be adjusted by the MASTER 2 control.

W DIGITAL OUTPUT

The digital output of the VRM10 is equipped in the S/P DIF standard. The signal path is switched parallel with MASTER 2 and can be controlled via the MASTER 2 (52) knob.

NOTE: To achieve the optimum sound performance and lowest signal-to-noise ratio it is essential in the digital out- put section to set the output impedance of the mixer to the highest possible level (control 52) and if necessary to lower the volume of the digital equipment connected to the VRM10 receiving signal.

The main outputs of the VRM10 (MASTER 1+ 2 and BOOTH) are equipped with a special patented circuitry to prevent crackling noise in the signal while switching the unit on or/and off. In any case you should make sure, that the mixer is switched on before the rest of your equipment, i.e. especially amplification e.g. This will pre- vent possible damage to you speakers and PA system. When turning off your equipment, you should proceed the opposite way; this means: first turn off the amplifica- tion, then the VRM10 mixer.

CONTROL INTERFACE (Front Panel)

1	Power On/Off	LED will light up right away. The valves in the signal path of
2	LED Power	the VRM10 will light up fully after a warm up period of 1-2

After pressing the VRM10’s power switch, the blue power minutes.