MICROPHONE CHANNEL
3DJ MIC 2
4DJ MIC 1
Both mic inputs can be used as symmetrical or non- sym- metrical (balanced or
THE XLR jack are set as follows:
1 | GND |
2 | +SIGNAL |
3 |
THE 1/4” Jacks are set as follows:
TIP+SIGNAL
RING
SHAFT GND
5GAIN 2
6CLIP LED for MIC 2
7GAIN 1
8CLIP LED for MIC 1
With the GAIN controls for both MIC channels you can set
the level for the preamplification of the microphones.
9TREBLE
10MIDDLE
11BASS
The 3 band EQ adjusts the equalization level for both microphone inputs.
12 VOLUME
The volume control adjusts the equalization level for both microphone inputs.
The Microphone channel is routed directly to the MASTER section in the output (please also see block diagram). This means:
-The microphone channel will not be influenced by the external effect send
-The microphone channel can not be heard through headphones
-The microphone channel will not be shown through the indicator tubes in the master section
NOTE : The signal and clip led’s will be affected by the microphone channel.
INTERNAL DSP EFFECTS
13EFFECT SELECT
With this control you can select one of the 16 selectable effect presets:
POSITION | TYPE | CHARACTER | TIME |
H1 | Hall Reverb | Concert | 2,4 sec |
H2 | Hall Reverb | Arena | 3,6 sec |
R1 | Room | Club | 1,8 sec |
R2 | Room | Chamber | 1,0 sec |
R3 | Room | Garage | 0,8 sec |
P1 | Plate | Plate | 2,0 sec |
P2 | Plate | Vocal | 1,5 sec |
SP | Spring |
| 3,4 sec |
F1 | Chorus/ Flange |
| 7m sec |
F2 | Chorus/ Flange |
| 12m sec |
F3 | Chorus/ Flange |
| 25m sec |
F4 | Chorus/ Flange |
| 35m sec |
D1 | Stereo Delay |
| 200m sec |
D2 | Stereo Delay |
| 300m sec |
D3 | Stereo Delay |
| 400m sec |
D4 | Stereo Delay |
| 500m sec |
14 EFFECT LEVEL
This controls the volume of the effect signal
15 FEEDBACK
With this control you can set the feedback of your selected effect. This function only works with the CHORUS/ FLANGE and STEREO DELAY effects.
16 SPEED
With this control you can adjust the frequency of the LFO
17 FACTOR
With this control you can adjust the Time factor of each
3