SoundCraft 1GB2 manual GB2 User Guide

Page 12

WARNINGS

Read these instructions.

Keep these instructions.

Heed all warnings.

Follow all instructions.

This unit contains no user serviceable parts. Refer all servicing to a qualified service engineer, through the appropriate Soundcraft dealer.

Clean the apparatus only with a dry cloth.

Do not install near any heat sources such as radiators, heat resistors, stoves, or other apparatus (including amplifiers) that produce heat.

Do not block any ventilation openings. Ventilation should not be impeded by covering the ventilation openings with items such as newspapers, table cloths, curtains etc. Install in accordance with the manufacturer’s instructions.

Do not use this apparatus near water. The apparatus must not be exposed to dripping or splashing. Objects containing liquid must not be placed on the apparatus.

The disconnect device is the mains plug; it must remain accessible so as to be readily operable in use.

Do not defeat the safety purpose of the polarized or grounding type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding prong. The wide blade or the third prong are provided for your safety. When the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet.

Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles and the point where they exit from the apparatus.

Only use cables and hardware specified by the manufacturer.

Unplug this apparatus during lightning storms or when unused for long periods of time.

Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally or has been dropped.

It is recommended that all maintenance and service on the product should be carried out by Soundcraft or its authorised agents. Soundcraft cannot accept any liability whatsoever for any loss or damage caused by service, maintenance or repair by unauthorised personnel.

If a trolley is used to carry this apparatus, use caution when moving the trolley / apparatus combination to avoid injury from tip-over.

No naked flame sources, such as lighted candles or cigarettes etc., should be placed on the apparatus.

Warning: To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture. Do not expose the apparatus to dripping or splashing and do not place objects filled with liquids, such as vases, on the apparatus.

GB2 User Guide

11

Image 12
Contents Page GB2 User Guide GB2 User GuideGB2 User Guide Contents GB2 User Guide Introduction Key Features Warranty GB2 User Guide Installation Safety Symbol GuideImportant Safety Warnings GB2 User Guide Mains Installation General PrecautionsPower Cable General Wiring ProceduresInitial Wiring Considerations Audio WiringShielding Points to Remember Recommended headphone impedance is 50-600 ohmsSetting Up & Troubleshooting TroubleshootingInitial set-up Optional External Power Supply Meters not showing any signalAudio Connector Pinouts Dimensions Block Diagrams Input Channels Master Section / Outputs GB2 User Guide Using The Console Mono Input Rear Connectors Line Input 1/4 TRS JackEQ is switched in by the EQ switch Stereo InputMIC Input Left and Right 3 pin female XLR GB2 User Guide Master Section Mix L, R and Mono OutputsRecord Outputs Monitoring & PFL/AFLTalkback PSU Monitor LEDsRear Connector Panel Front Panel ConnectorsLamps Typical Specifications NoiseMark Up Sheets GB2 User Guide GB2 User Guide