SoundCraft 1GB2 manual GB2 User Guide

Page 3

IMPORTANT

Please read this manual carefully before using

your mixer for the first time.

© Harman International Industries Ltd. 2006

All rights reserved

Parts of the design of this product may be protected by worldwide patents.

Part No. ZM0344-01

Soundcraft is a trading division of Harman International Industries Ltd. Information in this manual is subject to change without notice and does not represent a commitment on the part of the vendor. Soundcraft shall not be liable for any loss or damage whatsoever arising from the use of information or any error contained in this manual.

No part of this manual may be reproduced, stored in a retrieval system, or transmitted, in any form or by any means, electronic, electrical, mechanical, optical, chemical, including photocopying and recording, for any purpose without the express written permission of Soundcraft.

Harman International Industries Limited

Cranborne House

Cranborne Road

POTTERS BAR

Hertfordshire

EN6 3JN

UK

Tel: +44 (0)1707 665000

Fax: +44 (0)1707 660742

http://www.soundcraft.com

2

GB2 User Guide

Page 2 Page 4
Image 3
Page 2 Page 4
Contents Page GB2 User Guide GB2 User GuideGB2 User Guide Contents GB2 User Guide Introduction Key Features Warranty GB2 User Guide Safety Symbol Guide InstallationImportant Safety Warnings GB2 User Guide General Wiring Procedures Mains InstallationGeneral Precautions Power CableInitial Wiring Considerations Audio WiringShielding Recommended headphone impedance is 50-600 ohms Points to RememberSetting Up & Troubleshooting TroubleshootingInitial set-up Meters not showing any signal Optional External Power SupplyAudio Connector Pinouts Dimensions Block Diagrams Input Channels Master Section / Outputs GB2 User Guide Using The Console Mono Input Line Input 1/4 TRS Jack Rear ConnectorsStereo Input EQ is switched in by the EQ switchMIC Input Left and Right 3 pin female XLR GB2 User Guide Mix L, R and Mono Outputs Master SectionPSU Monitor LEDs Record OutputsMonitoring & PFL/AFL TalkbackFront Panel Connectors Rear Connector PanelLamps Noise Typical SpecificationsMark Up Sheets GB2 User Guide GB2 User Guide
Top Page Image Contents