SoundCraft 1GB2 manual Lamps

Page 33

GROUP 1-4 INSERT POINTS (1/4” TRS Jacks)

Tip	Send Signal
Ring	Return Signal
Sleeve Ground

AUX 1-4 OUTPUTS (3-pin male XLRs)

Pin 1	Ground
Pin 2	Signal Hot
Pin 3	Signal Cold
AUX 5-6 OUTPUTS (1/4” TRS Jacks)
Tip	Signal Hot
Ring	Signal Cold

Sleeve Ground

MATRIX 1-2 OUTPUTS (3-pin male XLRs)

Pin 1	Ground
Pin 2	Signal Hot
Pin 3	Signal Cold

REC OUTPUTS (RCA Phonos)

Centre Signal

Screen Ground

2-TRACK INPUTS (RCA Phono)

Centre Signal

Screen Ground

Lamps

The 4-pin sockets on the fascia, which are marked ‘LAMP’, can be used for a range of commercially-available gooseneck lamps. The sockets provide a 12V supply.

32	GB2 User Guide

Image 33

Contents Page GB2 User Guide GB2 User GuideGB2 User Guide Contents GB2 User Guide Introduction Key Features Warranty GB2 User Guide Safety Symbol Guide InstallationImportant Safety Warnings GB2 User Guide General Precautions Mains InstallationPower Cable General Wiring ProceduresInitial Wiring Considerations Audio WiringShielding Recommended headphone impedance is 50-600 ohms Points to RememberSetting Up & Troubleshooting TroubleshootingInitial set-up Meters not showing any signal Optional External Power SupplyAudio Connector Pinouts Dimensions Block Diagrams Input Channels Master Section / Outputs GB2 User Guide Using The Console Mono Input Line Input 1/4 TRS Jack Rear ConnectorsStereo Input EQ is switched in by the EQ switchMIC Input Left and Right 3 pin female XLR GB2 User Guide Mix L, R and Mono Outputs Master SectionMonitoring & PFL/AFL Record OutputsTalkback PSU Monitor LEDsFront Panel Connectors Rear Connector PanelLamps Noise Typical SpecificationsMark Up Sheets GB2 User Guide GB2 User Guide