Program Input Section

PGM 1

INPUT

PHONO 1

LINE 2

LINE 1

MINMAX

BAL

-16dB +16dB

MID

-12dB +12dB

-16dB +16dB

EFFECT

PRE OFF POST

CUE

OFFON

SIGNAL

LEVEL

○1 INPUT SELECTOR

Used to select input (2 line or 1 phono) to be sent to each PGM channel.

○2 TRIM CONTROL

Adjusts the Input level of each channel. Set INPUT FADER to 7- 8position. adjust TRIM so that the INPUT LEVEL METER shows about 0dB.

○3 BALANCE CONTROL

Adjusts the stereo balance for each PGM channel. Can be used for adjusting the unbalanced stereo image caused by a strong anti-skating setting. Clockwise rotation from center position increases the volume of R over L channel. A counter clockwise rotation increases the volume of L channel over R.

○4 EQUALIZER(HI,MID,LOW)

Adjusts the HI, MID, LOW frequencies for each PGM channel. Each band has following specifications.

HI 8kHz ±16dB

MID 500Hz ±12dB

LOW 80Hz ±16dB

○5 EFFECT SWITCH

This switch enables the signal from each programs to be sent to AUX send jack. Different signal routes can be selected this switch to different positions.

P R E :	The signal before the input fader (after the EQ) will be sent to AUX
	output.
POST :	The signal after the input and cross fader will be sent to AUX
	output.
O F F :	No signal will be sent to AUX output.

○6 CUE SWITCH

Used to send the signal from each program to monitor section for headphone monitoring.

○7 INPUT FADER

Used to adjust the Input level of each program. Usually set at the 7-8 position. This is a detachable fader for the ease of replacement. Replace with the IF-175 when it is worn out.

○8 CROSS FADER

When the Input level of PGM1 and PGM2 are properly set, PGM1 will be heard with the cross fader set to the left side. PGM2 will be heard with the cross fader set to the right side. When the cross fader is set in the center, both programs will be heard. This is detachable fader for the ease of replacement with "CF-PCV" when it is worn out.

CF-PCV For

PMC SERIES ( PMC05ProII, PMC06ProA, etc)

Insert the � multi-cable connector