Vestax PMC-55 owner manual Rear Panel, Ground Terminal, AC Power Cable, Balance OUT Level Switch

Page 10

55/E/面付け 00.9.12 4:44 PM ページ 11

REAR PANEL

 

 

45

 

 

 

43

 

41

 

 

 

 

 

 

 

 

 

 

 

PROFESSIONAL MIXING CONTROLLER

 

 

 

 

C A U T O N

 

 

 

 

 

PMC-55

 

WARNING;SHOCK HAZARD-DO NOT OPEN.

 

RISK OF ELECTRIC

 

 

 

 

 

 

AVIS;RISQUE DE CHOC ELELCTRIQUE -NE PAS OUVRIR.

 

SHOCK. DO NOT OPEN

 

MASTER 1

 

 

 

 

 

 

 

 

 

R

 

L

MASTER 1

AUX SEND

LINE 7

 

LINE 5

 

LINE 3

LINE 1

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

37

 

 

 

 

 

 

 

MASTER 2

 

AUX RTN

 

 

 

 

 

38

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

R

L R

L

R

L R

L

 

 

 

 

 

 

 

 

 

 

PHONO 4

 

PHONO 3

 

PHONO 2

PHONO 1

 

 

 

 

 

 

 

BOOTH OUT

 

CUE OUT

 

 

 

 

 

39

 

 

 

 

 

 

 

 

 

 

 

 

GND

 

GND

R

MASTER 2

 

L

 

 

 

 

 

 

 

GND

 

 

 

 

 

 

 

 

 

 

 

 

PIN 1

GND

 

 

 

 

 

 

 

 

 

 

SERIAL NO.

 

 

PIN 2

HOT

-20

-10

0(dB)

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

AC100V

50 / 60Hz 20W

MADE IN JAPAN

 

PIN 3 COLD

BAL OUT LEVEL

R

L

R

L

MIC 2

MIC 1

 

 

 

 

 

 

 

46

 

 

47

 

44

 

42

40

 

 

 

 

37

 

 

 

 

 

 

 

 

43

 

 

 

 

 

 

LINE IN 1, 3, 5, 7 (RCA)

 

 

 

MASTER OUT 1, 2 (1/4" Phone, Unbalanced)

They work the same as LINE IN 2, 4, 6, 8 (1).

38 PHONO IN 1, 2, 3, 4 (RCA)

Connects turntable output equipped with MM type pickup cartridge. If MC type cartridge is used, a pre- amp is required.

39 GROUND TERMINAL

Connects to ground lead of the turntable. This helps to reduce noise and hum.

40 MIC 1, 2 (1/4" Phone)

Input jack for connecting the microphones.

41 AUX SEND/RETURN (1/4" Phone)

Connects to outboard effects such as Delay machine. AUX SEND is located on pre-input fader.

42 CUE OUT (1/4" Phone)

When CUE ASSIGN(11) is depressed,the signal comes out from this jack. It can be used for sampling source output.

Connects to the input of power amplifier. These jacks are Phone type for consumer applications. This mixer has two pairs of MASTER OUT. And each output level can be set separately. This means that MASTER OUT (43) can be used for main output and sub. For example, one for hall, the other for entrance.

44 BOOTH OUT (1/4" Phone)

This can be used for DJ booth monitor. Same signal as HEADPHONES OUT comes out.

45 MASTER OUT 1, 2 (XLR, Balanced)

Connects to the input of power amplifier. These connectors are XLR type for professional audio applications. They works the same as Unbalanced MASTER OUT 1, 2 (43). Pin No.3 for HOT.

46 AC POWER CABLE

Connects the plug to AC outlet on the wall.

47 BALANCE OUT LEVEL SWITCH

Used to select the output level of the MASTER OUT 1.2.

9

Image 10
Contents 55/E/面付け 00.9.12 444 PM ページ Page Page A T U R E S Control and Functions MIC LevelProgram Input Section Crossfader Section Microphone SectionMaster Section Monitor Section Front PanelRear Panel AC Power CableBalance OUT Level Switch Ground TerminalBlock Diagram Connection PMC-55Boost Cancel SW/TRIM Level Select SW Boost Cancel SwitchSpecifications THDVestax Corporation