Getting Connected, Source Inputs | VocoPro DA-900 specs

Getting Connected

The DA-900 has two audio input channels for source players. Each device connection will require one RCA-type stereo patch cable.

To connect the source players, follow the steps below:

(a)Connect an RCA-type stereo patch cable from the AUDIO OUTPUT jacks on the SOURCE PLAYER to either of the two AUDIO INPUT channels on the DA-900.

(b)Repeat the above for a second SOURCE PLAYER using the available INPUT on the DA-900.

Source Inputs

MIC ONLY

OUTPUT

INPUT MUSIC

CDG DVD ONLY

INPUT OUT

MIXED

LINE PRE

OUTPUT

CAUTION

RISK OF SHOCK

CAUTION: To reduce the risk of electric shock, do not remove cover (or back). No user- serviceable parts inside. Only refer servicing to qualified service personnel.

LAVERNE CALIFORNIA

U.S.A

SERIAL NO.

To Audio OutTo Audio Out

CD PLAYER 2

MP3 PLAYER

While both input channels are designated with a device name (DVD and CDG), any compatible device can be connected to them. NOTE: If there is a needed video connection from one of the source players, connect the video straight from the source player to the TV or display device. The device names are for convenience only, and not meant to prevent one from connecting a different compatible device.

The DA-900 has four pairs of RCA-type OUTPUTS for connection to external devices:

PRE-OUT (1): This OUTPUT is for connecting the DA-900 directly to an external amplifier. Output signals from these PRE-OUT jacks are suited for amplifiers with no VOLUME control. If your amplifier has input jacks other than RCA, obtain an appropriate set of cables to match the inputs on your amplifier

(a)Using an audio patch cable, connect the RCA side to the PRE-OUT jacks on the DA-900 and connect the other sides plugs to the amplifier's AUDIO IN or CH. A/B jacks.

Pre-Out

MIC ONLY	INPUT MUSIC		MIXED
	CDG DVD	ONLY	LINE PRE
OUTPUT	INPUT	OUT	OUTPUT