VocoPro PA-PRO 900 owner manual Rear Panel Features

Page 14

Rear Panel Features

 

 

REAR PANEL FEATURES

1.POWER CONNECTOR – Connect the supplied 3-prong power cord to this connector.

1a. NOTE: Before plugging in to a power receptacle, make sure that voltage of your PA-PRO 900 is the same voltage as your local AC mains voltage. The PA-PRO 900 power input setting is factory set.

2.FUSE HOUSING – Houses the fuse. To remove the fuse, unscrew the fuse cap counter-clockwise. In the case of a blown fuse, replace once only. If the fuse blows a second time, do not attempt to replace fuse again. If a fuse blows repeatedly, there may be damage an internal component. Further attempts to power on the unit can cause more damage. In this case, refer to an authorized service center for troubleshooting

2a. NOTE: Only replace with the same type and rating of fuse as marked.

3.WIRELESS MODULE EXPANSION PORTS – Install optional UHF wireless modules in these ports. For details on operating UHF wireless channels, please refer to the optional accessories section. (page 23)

To install an optional module:

1.Unscrew the two retaining screws.

2.Remove cover plate and store it in a safe place.

3.Fully insert UHF wireless module.

4.Replace and tighten screws.

4.WIRELESS ANTENNA CONNECTORS – When the optional wireless modules are installed, connect the antennas here for UHF wireless reception.

 

��

 

��

5.SPEAKER CONNECTORS – These jacks provide speaker- level output power from the internal power amplifi er to connected passive speakers. There are two types of connector available: speakon and ¼” TS.

Speakon outputs are wired PIN 1+positive (hot), and PIN 2-negative (cold).

¼” TS outputs are wires TIP +positive, and SLEEVE –negative.

The speaker-level output can be confi gured one of two ways via the POWER AMP ASSIGN switch on the front panel:

MAIN L/R – This confi guration is for standard MAIN stereo L/R output. The left speaker output is the MAIN L signal, and the right speaker output is the MAIN R signal. Use this confi guration to power two passive main speakers for straight stereo output.

MAIN L/R+MONITOR – This confi guration outputs the MAIN L/R channels as a mono signal to the LEFT (MAIN) jacks, and the MONITOR channel as a mono signal to the RIGHT (MON) jacks. Use this confi guration to power a passive PA/MAIN speaker on the left side and a passive stage monitor on the right side.

NOTE: If you are going to use one speaker per channel, ensure the speakers’ impedance is no lower than 4 ohms. If you are going to connect two speakers per channel, ensure the speakers’ impedance in no lower than 8 ohms. These two types of connectors are wired in parallel, therefore they are able to be used together.

14

Image 14
Contents PA- RO Table of Contents Risk of Shock FCC Information Welcome Listening for a Lifetime Some common decibel rangesFeatures Hookup Diagrams +MONITOR Hookup Diagrams Hookup Diagrams Hookup Diagrams +MONITOR Rear Panel Features Rear Panel FeaturesFront Panel Features Channel StripsPatch BAY MIC/LINE CH ST CH Effect LoopCompressor CH.1-4 DSP REV ControlST CH Effect Loops Front Panel Features Front Panel Features Front Panel Features Front Panel Features Optional Accessories Optional Accessories Optional Accessories PA-PRO 900 Specifications Technical Specifi cationsChannel EQ Compress Limit Power Consumption Page Troubleshooting There is no powerVocoPro 2010