Rear Panel | Crate Amplifiers CMX62 specification

CMX62 Stereo Console Mixer

The Master Section (continued):

48TAPE IN PFL: This switch, when depressed, sends the signal from the tape In jacks (#35) to the Monitor master control (#51). The Output LED Meters (#57) are also switched to monitor this signal, which is pre-level control. The PFL LED (#55) illuminates to indi- cate that the Headphones (#39), Monitor (#42) and LED Meters (#57) are now responding to the PFL selection.

49AUX OUT: Controls the level of the signal sent to the Aux Out jack (#36).

50EFFECTS OUT: Controls the level of the signal sent to the Eff Out jack (#38).

51MONITOR: Controls the level of the signal sent to the Monitor jacks (#42).

52GRP / L/R: This switch determines whether the Monitor section is monitoring the Main L/R output or the Group 1/2 output.

53GROUP TO L/R: This switch, when depressed, sends the Group 1/2 signal to the Main L/R fader (#60).

54AFL: This switch, when depressed, sends the Group 1/2 post-fader signal to the Monitor master control (#51).

55PFL LED: This LED illuminates when any of the PFL or the AFL switches are depressed, indicating that the Meter (#57) is monitor- ing a PFL selection.

56POWER LED: This LED illuminates when the mixer is plugged into an AC source and the Power switch (#62, rear panel) is at the On position (“–” depressed).

57METER: This dual 12-stage LED meter monitors the Main L/R out- put signals under normal conditions – if any of the PFL / AFL switches are depressed, the PFL LED (#55) will illuminate and the meters will monitor the PFL source(s). The Peak LEDs will illumi- nate whenever the output signal is near clipping. If this happens, reduce the master faders until the Peak LEDs no longer flash.

58MONO: Controls the level of the signal at the Mono jack (#37). This signal is a mono summed version of the Main L/R signals.

59GROUP 1/2 FADERS: Control the Group 1 and 2 master signal levels sent to the Group 1 and 2 jacks (#41).

60MAIN L/R FADER: Controls the Main master signal level sent to the Main Left/Right jacks (#40).

The Rear Panel:

61POWER CONNECTOR: Fasten the threaded collar of the supplied AC power supply to this connector. Align the pins of the power supply with those of the connector, press into place, then tighten the threaded collar onto the connector securely.

62POWER: Use this switch to turn the mixer on (“–” depressed) and off.

63PHANTOM POWER: When using any condenser microphone that requires phantom power use the tip of a small screwdriver to slide the corresponding DIP switch to the On position (switch down). This applies

phantom power to the appropriate channel. Phantom power is only available if the Master On/Off switch (#64) is in the On position. The numbers below the switches correspond to channels 1 – 6 of the mixer.

64MASTER ON/OFF: This switch turns the phantom power supply on and off. This switch must be on for the channel DIP switches (#63) to function.

NOTE: Turn the master faders and monitor controls down to minimum when turning the phantom power on and off to avoid transient signals from entering your amplifier(s).