Crate Amplifiers CMX62 manual Master Section, 3334

CMX62 Stereo Console Mixer

The Master Section:

3334

35

36 37

38 39

40

41

42

33	AUX RET: Returns the stereo or mono signal from an external device.
	Stereo devices use both the Left and Right jacks; mono devices use
	only the Left jack.
34	EFF RET: Returns the effected signal from an external effects device. Stereo
	devices use both the Left and Right jacks; mono devices use only the Left
	jack.
35	TAPE IN/TAPE OUT: Connect to the record and play jacks of an exter-
	nal tape deck. (See page 13.)
36	AUX OUT: Sends the Aux signals to an external device. The mix at this
	jack is determined by the setting of each channel’s Aux control (#9, #24).
37 MONO: The signal at this jack is a summed mono version of the Main L/R
	signals. The level at this jack is controlled by the Mono master control (#58).
38	EFF OUT: Sends the Effect signal to an external effects device. The mix
	at this jack is determined by the setting of each channel’s Eff control
	(#11, #26).

44	46
43	45		55	56
	47	48
				57
	49	50
	51	52
	53	54	58

59 60

6

39	HEADPHONES: Normal operation: monitors the Main L/R or Group
	1/2 signals, depending on the setting of the Grp / L/R master switch
	(#52). When one or more of the PFL or AFL buttons are depressed the
	signal at this jack is switched to monitor only the PFL selection(s). The
	signal level at this jack is controlled by the Monitor master control (#51).
40	MAIN OUTS: These balanced jacks send the Main L/R output signals
	to the house amplifier(s). (See pages 8-12.) The signal level at these
	jacks is controlled by the Main L/R fader (#60).
41	GROUP OUTS: These balanced jacks send the Group 1/2 output sig-
	nals to the house amplifier(s). (See pages 8-12.) The signal level at
	these jacks is controlled by the Group 1/2 fader (#59).
42	MONITOR OUTS: These balanced jacks send the Monitor output sig-
	nals to the local reference monitor amplifier(s). (See pages 8-12.) The sig-
	nal level at these jacks is controlled by the Monitor master control (#51).
43	AUX RTN: Controls the signal level sent from the Aux Rtn jacks (#34)
	to the Main L/R bus.
44	AUX PFL: This switch, when depressed, sends the signal from the Aux
	Rtn jacks (#33) to the Monitor master control (#51). The Output LED
	Meters (#57) are also switched to monitor this signal, which is pre-level
	control. The PFL LED (#55) illuminates to indicate that the
	Headphones (#39), Monitor (#42) and LED Meters (#57) are now
	responding to the PFL selection.
45	EFF RTN: Controls the signal level sent from the Aux Rtn jacks (#33) to
	the Main L/R bus.
46	EFF PFL: This switch, when depressed, sends signal from the Eff Rtn
	jacks (#34) to the Monitor master control (#51). The Output LED
	Meters (#57) are also switched to monitor this signal, which is pre-level
	control. The PFL LED (#55) illuminates to indicate that the
	Headphones (#39), Monitor (#42) and LED Meters (#57) are now
	responding to the PFL selection.
47	TAPE IN: Controls the level of the signal from the Tape In jacks (#35)
	to the Main L/R bus. To avoid feedback, this control must be rotated
	fully counter clockwise (“0” position) when using both sets of Tape In
	and Out jacks during recording.