Sharp HT-SL50 System preparation, Driving screws, Using stand, Using foot cushions

System preparation

Make sure to unplug the AC power lead before installing the unit or changing the position.

Select from three installation methods according to the preferred position.

Using stand

1.Peel off the double sided tape separator and attach the sound bar stand cushion at the bottom surface of the sound bar stand.

Sound bar stand cushion

Sound bar

stand

Double sided tape separator

Hook

2. Fix the sound bar stand as shown.

Option 1

Option 2

Note:

Sound bar stand can be removed by pulling it off backward from the sound bar.

Using foot cushions

Option 1

Option 2

Option 1

Option 2

Attach foot cushions as shown

To mount the sound bar on the wall

Caution:

●Be very careful to prevent the sound bar [0.66 kg

(1.46 lbs)] from falling when mounting on the wall.

●Before mounting, check the wall strength. (Do not put on the veneer plaster or whitewashed wall. The sound bar may fall.) If unsure, consult a qualified service technician.

●Mounting screws are not supplied. Use appropriate ones.

●Check all wall mount angle screws for looseness.

●Select a good location. If not, accidents may occur or the sound bar may get damaged.

●SHARP is not responsible for accidents resulting from improper installation.

●Do not let children dangle on the sound bar once it is attached on the wall as it can cause damage and injury.

■Driving screws

SHARP designed the sound bar so you may hang them on the wall. Use proper screws (not supplied). See below for size and type.

3.2 mm (1/8")

5 mm
(3/16")	9 mm (3/8")
	Min. 22 mm (7/8" )

E-4