Sharp HT-SL50 Falling prevention, Fixing wall mount angle, Installing the sound bar

System preparation (continued)

■Fixing wall mount angle

1 Fix the pattern paper to the wall in horizontal position as below.

■ Installing the sound bar

1 Align the wall mount slot at the sound bar to the

wall mount angle.

523 mm

Wall surface 30 mm

30 mm

2	Slot the sound bar into the wall mount angle.
3	Fix them securely.

Wall surface

Pattern paper

2Make a hole on the wall following the screw point marks on the pattern paper by using a drill.

32 mm (1-1/4")

8-9 mm (3/8")

Wall surface

3Fix a wall mount plug (not supplied) into the hole using a hammer, until it is flush with the wall surface.

32 mm (1-1/4")

8-9 mm (3/8")

Wall surface

4Screw the wall mount angle to the wall as shown in the illustration. (Total screw is 4 pieces)

Wall mount angle

Wall mount
angle	Wall	Wall
(screws x 2)	surface	mount
		angle
Wall surface
(screws x 2)
Wall surface

Note:

Make sure all screws are fully tightened. (screws are not supplied)

Falling prevention

Safety wires (not supplied) are useful to prevent the sound bar from falling off the table.

L

R L

R

Loop the safety wires (not supplied) into each hole as shown and tie the safety wires to the LCD TV stand.

E-5