Multiquip WC-62S manual WC-62P/S Concrete Mixer Initial START-UP Electric Motor

WC-62P/S CONCRETE MIXER — INITIAL START-UP (ELECTRIC MOTOR)

Initial Start-up Instructions (Electric Motor)

Starting

CAUTION:

DO NOT attempt to operate the mixer until the Safety, General Information and Inspection sections have been read and understood.

1.Before starting, make sure mixer is positioned on a secure flat surface to prevent rolling.

2.Use an extension cord (see Table 5) of adequate current carrying capacity, insert the electric motor's power plug into one end of the extension cord.

3.NEVER! use a worn or frayed extension cord.

4.NEVER! operate mixer withV-belt cover removed.

DANGER

NEVER! touch the power cord (Figure 16) with wet hands or while standing in water when it is connected to a power source.The possibly exists of electrical shock (electrocution) even death. NEVER! spray water directly on the electric motor.

Figure 16. Extension Cord (Wet Hands)

To prevent personnel from tripping over the extension cord, position the

NOTE extension cord so that it lays flat and is not curled underneath the mixer.

5.Place the voltage selector switch (Figure 17) in the position thatisinaccordancewithvoltagelistedontheelectricmotor's nameplate. Theelectricmotor'sareshippedfromthefactory withthewiththevoltageselectorswitchplacedinthe115VAC position.

If 230VAC is required, remove the locking bolt and nut and flip the voltage selector toggle switch to the 230 VAC position. Reinstall the locking bolt and nut to prevent the toggle switch from being accidently tripped.

Figure 17. Voltage Change Switch

(115 VAC Position)

6.Plug the other end of the extension cord into either a 115 or 230 VAC power source (look at position of voltage selector switch). Remember to read the nameplate to determine the motor's input voltage requirement.

WARNING:

ALWAYS read the label on the electric motor before applying power.The label will indicate the correct power requirements for the motor. Remember the use of an incorrect input voltage will severely damage the electric motor.

Starting the Electric Motor

1.Set the electric motor's ON/OFF switch (Figure 18) to the ON position.

Figure 18. Electric Motor ON/OFF Switch (ON Position)

PAGE 22 —WC-62P/S CONCRETE MIXERS — PARTS & OPERATION MANUAL — REV. #7 (06/30/05)