Controls and Features |
Top Panel
7
6
5
4
3
2
1
8 | 9 | 10 | 11 | 12 |
13
14
15
16
17
18
19
1.FEATHER FADER PLUS CROSSFADER - This fader is used to blend the output signals of chan- nels one and two together. When the fader is in the full left position (channel 1), the output signal of channel one will be controlled by the master volume level. The same fundamentals will apply for chan- nel two. Sliding the fader from one position to another will vary the output signals of channels one and two respectively. When the crossfader is set in the center position, the output signals of both the chan- nels one and channels two will be even.
2.HAMSTER SWITCH - This switch changes the polarity of the Crossfader (for crabbing). Channel
1will be activated by the right side of the crossfader (mixing from right to left), and Channel 2 will be activated by the left side of the crossfader (mixing from left to right).
3.CHANNEL FADER - These faders are used to control the output signal of any source assigned to its particular channel.
©American Audio® - www.americandj.com -