American Audio Q-D3 manual Controls and Features

20.AC VOLTAGE SELECTOR - This switch is used to adjust the operating voltage. Operating voltage can be toggled between 115V/50Hz or 230V/60Hz. Always be sure the selector is set to the proper voltage for your area before attempting to operate the unit.

21.PLAYER CONTROL - These jacks are used to control the “Q-Start” function between the mixer and a compatible American Audio CD Player. Input mini plugs from CD player controller into these jacks, input CD 1 into jack A and CD 2 into jack B.

22.LIGHT CONTROL - This jack provides a preset mono audio signal output. There is no way to adjust this level, however this level will directly refl ect the output level of the Channel Faders (3). This buffered audio output should only be used for light controllers that can accept an external audio input. Great for Touch Panels and Chase Controllers. Buffered audio output for light controllers that can use external input.

23.DJ MICROPHONE CONNECTOR - This jack is used to a connect a microphone to the mixer. Con- nect you microphone via 1/4 inch (6.3mm) jack. The signal volume will be controlled by the DJ Mic Knob

(7). The bass and treble levels can also be adjusted by the built-in microphone EQ (7).

24.AC CONNECTION - This connector is used to supply main power to the unit via the included detachable power cord. Use only the supplied, polarized AC power cord. This cord is designed to fi t in one direction only. Do not attempt to force a cord in if it does not fi t, be sure the cord is being inserted properly

25.RCA MASTER OUTPUTS - The Master Output includes a pair of RCA Unbalanced Jacks. The RCA jacks send a low current unbalanced output signal.

©American Audio® - www.americandj.com - Q-D3™ Instruction Manual Page 8