TP-Link RX-7-248 Power Supply Unit RPS-7, AC Fuse, Pilot Lamp Power Switch, DC output connector

Page 22

Power Supply Unit (RPS-7)

In order to minimize hum, and also to break up the total weight and to protect the body of the RX-7 from rough transportation, RX-7 series mixers are equipped with a separately packaged power supply unit (RPS-7).

The RX-7 is designed so that without the connection of the accessory umbilical cable between the PSM-7 power supply module and the RPS-7, power is not supplied to the mixer even if the power switch on the RPS-7 is on. The power switch on the RPS-7, therefore, must be turned on after the connection between the PSM-7 and RPS-7 is completed.

The RPS-7 is a regulated DC power supply unit to activate the RX-7.

(Fig. 14)

1. AC Fuse

The fuse should be replaced with one of identical value and type.

2.Pilot Lamp

3.Power Switch

Pushbutton alternately switches AC power on and off.

4.DC output connector

With the accessory umbilical cable, the DC output is connected to the PSM-7 (Power Supply Module).

5.Ground Terminal

6.AC Inlet

Plug an accessory AC power cord into the AC inlet and secure it with the cord clamp.

— 21 —

Image 22
Contents TOA Mixing Console Contents Precautions General Description Input Module FeaturesGROUP/FOLDBACK and GROUP/ECHO Modules Phones Module Program ModuleTalkback Module Specifications & Characteristics General Specifications RX-7-164, RX-7-248 and RX-7-328RX-7 Output Characteristics Input & Output SpecificationsRX-7 Input Characteristics Power Supply Unit RPS-7 SpecificationsLevel Diagrams Characteristics Diagrams Equalizer CurvesInput Module IPM-7 Page Group/Foldback Module GFM-7 LOWGroup/Echo Module GEM-7 Program Module PGM-7 Program OUT a SectionPhones Module PHM-7 Talkback Module TBM-7 Power Supply Module PSM-7 Meter Panel RXM-7-25, RXM-7-35, RXM-7-43 Group I/Program 1 VU MeterVU meter selector switch Cue or Talkback Meter Panel RXM-7-35 Meter Panel RXM-7-43 DC output connector Power Supply Unit RPS-7Pilot Lamp Power Switch AC FuseDifference between Professional and HI-FI type equipment General Information on using the mixing consoleImpedance Balanced type and unbalanced typeGround loops Phase Switch Phantom Power SwitchFunction Details Input Level Switch & Trim Control Equalization Chart EqualizersInstrument Equalization Chart Group/Foldback, Group/Echo Modules Equalizer IN/OUT SwitchFoldback 1, 2 and Echo 1 Program ModuleRX-7 Signal Flow Phantom Power Master Switch Power Supply ModuleAir Monitor Ceiling Microphones Connection Example Mic SettingPortable Entertainment Sound Reinforcement Set-Up Accessory Send on each input channel also available Multi-Track Recording or Track-DownModule Replacement How to remove modulesUse fingers to lift up the module Dimensional Diagrams RX-7-164 AppearanceRX-7-248 Appearance RX-7-328 Appearance Group/Echo Modules GEM-7RXM-7-25 Appearance Bus Chassis Wood Side PanelRXM-7-35 Appearance RXM-7-43 Appearance RPS-7 Appearance Block Diagram 133-02-476-20