Connecting Speakers

Getting Connected

The Speaker Terminals are located on the rear panel. There are two STEREO terminals. Be sure to connect the left channel (L), right channel (R), “+” (red) and “--” (black) properly.

��

Preparing the Speaker Cable

You can either used an exposed speaker wire or Banana Plug speaker cable.

Exposed Speaker Wire

1. Remove approximately 3/8” (10mm) of insulation.

��

WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE

CAUTION: TO PREVENT ELECTRIC SHOCK, DO NOT REMOVE COVER SCREWS. NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

��

110V

220V

THE POWER

SUPPLY CORD

SHOULD BE

DISCONNECTED

BEFORE

CHANGING THE

VOLTAGE

SELECTOR

��

CAUTION: TO REDUCE THE RISK OF FIRE, REPLACE ONLY WITH SAME TYPE FUSE

��

2.Twist the exposed wires together to prevent short circuits.

•Before connecting the speakers, make sure that the KR- 3808 PRO is disconnected from the power source.

•Do not let the bare speaker wires touch each other or another metal part of this unit. This could damage the KR- 3808 PRO and/or the speakers.

Determining the proper way to connect the speaker cables:

The speaker cable is a pair of insulated cables running side by side. One cable is colored or shaped differently, perhaps with a stripe, groove or ridges.

1.Connect one end of the striped (grooved, ridged, etc.) cable to the “+” (red) terminal on the rear panel of the KR-3808 PRO.

2.Connect the other end of the striped (grooved, ridged, etc.) cable to the “+” (red) terminal on the speaker.

3.Connect one end of the “plain” (NO stripes, grooves, ridges, etc.) cable to the “--” (black) terminal on the rear panel of the KR-3808 PRO.

4.Connect the other end of the “plain” (NO stripes, grooves, ridges, etc.) cable to the “--” (black) terminal on the speaker

��

4.Insert the bare wire.

5.Tighten the knob until the wire is secure.

��

Using Banana Connectors

1.Plug the Banana connectors into the speakers, ensuring the black and red connectors are aligned properly.

2.Plug the other ends of the cables into the KR-3808 PRO’s speaker output, ensuring the black and red connectors are aligned properly.