USING THE PK-6000: GENERAL
First Use of the PK-6000
The first time you use this device, ensure that you have installed fully charged batteries. Hold down the power button for several seconds to start the device. To calibrate the Stylus for continued use, enter “Menu Settings” and select “Screen Calibration.” You will be taken through several steps as shown below to click the touchscreen with the Stylus to ensure its correct operation. Important: Do not power off before completing the calibration or you will have to repeat the steps. If you upgrade firmware or reset your PK- 6000 to its original factory settings, you will have to perform the calibration again.
The text on the first two calibration screens advise you to “Please check the cross carefully” with the Stylus. The final screen reads “Adjust OK” after you have successfully clicked your way through.
(11)