Back Panel Back Panel Features, Fuse | Peavey PZS 140 instruction

BACK PANEL:

15	16	20
		17
	21	18

	22	19
		19
25		25
		24

BACK PANEL FEATURES:

15.FUSE

The fuse is located within the cap of fuseholder. If the fuse should fail, IT MUST BE REPLACED WITH ONE OF THE SAME TYPE AND VALUE IN ORDER TO AVOID DAMAGE TO THE EQUIPMENT AND TO PREVENT VOIDING THE WARRANTY. If the amp repeatly blows fuses, it should be taken to a qualified service for repair.

WARNING: THE FUSE SHOULD ONLY BE REPLACED WHEN THE POWER CORD HAS BEEN DISCONNECTED FROM ITS POWER SOURCE.

16.AC LINE CORD SOCKET

Provided to accept the removable AC line cord. Connect only to proper sourceÑsee back panel markings.

17.CHANNEL 1 and 2 XLR INPUTS

Normal low-Z mic inputs for cables fitted with a standard XLR male connector. The circuitry associated with this input is electronically balanced and is designed to accept any normal low impedance microphone. This receptacle is a standard three-pin XLR female wired as follows: Pin 1- ground

Pin 2- positive input Pin 3- negative input

OPERATION NOTE: 48 volt phantom power is always available on pins 2 and 3 with reference to pin 1.

18.CHANNEL 1 and 2 LOW-Z INPUT

Normal low-Z mic inputs for cables without connectors. Two conductor shielded cables should be carefully wired as follows:

Cable shield- GND Conductor 1- Low-Z positive Conductor 2- Low-Z negative

Normally conductor 1 should be the positive microphone output feed. If the polarity of the associated microphone is not known, one should be consistent in wiring all mics the same way. Again the circuitry associated with this input is electronically balanced and is designed to accept any normal low-impedance microphone.