Peavey I8B+ manual Speaker Outputs, Bridged Output, Monitor Output, Power Connector, Power Switch

Rear Panel

5

4 3 2 1

(1) SPEAKER OUTPUTS

These are four two-conductor 1/4" speaker outputs. Each one is rated at 4 ohms minimum impedance. Total minimum load for each amplifier channel is 4 ohms, except Bridged which is 8 ohms. You may connect either one 4-ohm (except Bridged), one 8-ohm or two 8-ohm speakers per output jack. Do not operate below rated minimum impedance. For maximum power transfer, be sure to use speaker cables and not instrument cables to connect to the speakers. We recommend the use of 18-gauge or larger speaker wire.

(2) BRIDGED OUTPUT

Two conductor 1/4" speaker output rated at 8 ohms impedance. Do not operate below minimum rated impedance.

(3) MONITOR OUTPUT

Two conductor 1/4" speaker output rated at 4 ohms impedance. Also, this serves as one of the main speaker outputs when in MAIN/MAIN mode. Do not operate below minimum rated impedance.

(4) POWER CONNECTOR

This is a standard IEC cable connector for use with standard voltages from AC wall outlets. Its safety ground pin is connected to the chassis and should never be removed (or defeated in the line cord) for any reason. The IEC connector contains an internal fuse holder. The fuse rating is 5 amperes.

(5) POWER SWITCH

This switches the unit on or off.

WARNING

THE ON/OFF SWITCH IN THIS APPARATUS

DOES NOT BREAK BOTH SIDES OF THE MAINS.

HAZARDOUS ENERGY MAY BE PRESENT INSIDE

THE ENCLOSURE WHEN THE POWER SWITCH IS

IN THE OFF POSITION.