topnut screws to allow the strings to pass through the string slots. Tune to pitch and tighten locking topnut screws until snug. DO NOT OVERTIGHTEN SCREWS.
String Installation
After loosening topnut screws (at headstock), use tuning machines to remove string tension. Loosen string lock bolts at bridge approximately three turns using the 3mm hex wrench. Insert string end through tuning machines and locking topnut. Cut off excess string length approxi- mately one inch past string of lock bolts. Insert string end into bridge saddle (between saddle housing and lock block) and tighten until snug. DO NOT OVERTIGHTEN. Adjust fine tuning knobs to middle position. Stretch strings and tune to pitch. Tighten locking topnut, stretch string once more and
D-Tuner Operation and Adjustment
The
“E” position
set screw
“D” position
1. Loosen the locking topnut screw for the
2. Adjust the
3.Turn the
8