Fostex FD-8 Setting the Record Protect function Rec Protect ? menu, Recording enabled/disabled

Changing the initial setting (SETUP mode)

<Notes>

•This menu is used to select a digital signal used for external synchronization when Slave mode is turned on. If you wish to specify the type of digital signals to record, you need to use the “Setting digital input tracks” menu.

•When you set the Slave type, the Vari Pitch function is automatically disabled. (The [VARI PITCH] indicator turns off.)

4. Press the EXECUTE/YES key.

The selected Slave type is stored, and [e] and [?] flash alternately.

To cancel the operation, or to restore the setting obtained prior to the EXECUTE/YES key press, press the STOP button or the EXIT/NO key. Each time you press one of these keys, the FD-8 returns to the previous hierarchy level of the menu, and finally exits SETUP mode and displays the previous Time Base.

<Notes>

•If you set the Slave type to [SP di F] (S/P DIF digital signal) or [Ad At] (adat digital signal), [DIGITAL] lights up on the display when the FD-8 receives a normal digital signal from the external device. If the signal is abnormal, the [DIGITAL] indicators flash to give you an alarm.

•If you set the Slave type to [SP diF] (S/P DIF digital signal), approximately two seconds of the sound in the entire system will be muted when the FD-8 locks or unlocks to clock. Make sure to input a stable digital signal source.

Setting the Record Protect function (“Rec Protect ?” menu)

The FD-8 features the Record Protect function, which is similar to the function of record-protect tabs on cassette tapes. The “Setting the Record Protect function” menu allows you to turn the Record Protect function on and off. When this function is turned on, you cannot record, paste, or erase data. Use this function to protect your precious data from being erased accidentally.

•Initial setting: [o FF]

•Option: [on] or [o FF]

*You can turn the function on and off for each Program individually.

*The settings can be saved and loaded as part of the song data.

*The settings are maintained after you turn off the power to the unit.

*The Program is automatically checked before the operation.

Recording enabled/disabled

1.While the FD-8 is stopped, press the SETUP key to enter SETUP mode.

2.Turn the JOG dial to select [Rec Protct (?)] ([t] and

[?]flash alternately), then press the EXECUTE/YES

key.

The current setting appears on the display.

Pressing the EXECUTE/YES key turns off the flashing [?] character, and the recording enabled/disabled indicator flashes.

With the initial setting, [o FF] flashes as shown below.

44.1kHz

SETUP

3. Use the JOG dial to enable or disable recording.

Rotating the JOG dial clockwise and counter-clockwise will flash [on] and [o FF] alternately.

Selecting [o FF] enables recording; you can record, paste, and erase data.

Selecting [on] disables recording; and you cannot record, paste, or erase data.

Note: When recording is disabled (on) and you try to record, paste, or erase data, the FD-8 displays [Protected] for a second, indicating that you cannot perform the operation. To perform the operation, you need to enable recording (oFF).

SYNC OUT	DRIVE
CLK		SCSI
AUTO	A.PUNCH

	SETUP	44.1kHz
SYNC OUT		DRIVE
CLK			SCSI
AUTO		A.PUNCH

4.Press the EXECUTE/YES key.

[t]and [?] flash alternately.

To cancel the operation, or to restore the setting obtained prior to the EXECUTE/YES key press, press the STOP button or the EXIT/NO key. Each time you press one of these keys, the FD-8 returns to the previous hierarchy level of the menu, and finally exits SETUP mode and displays the previous Time Base.

108