DOD GS30 manual Electromagnetic Compatibility

Page 2

These symbols are internationally accepted symbols that warn of potential hazards with electrical products.The lightning flash means that there are dangerous voltages present within the unit.The exclamation point indicates that it is necessary for the user to refer to the owners manual.

These symbols warn that there are no user serviceable parts inside the unit. Do not open the unit. Do not attempt to service the unit yourself. Refer all servicing to qualified personnel. Opening the chassis for any reason will void the manufacturer’s warranty. Do not get the unit wet. If liquid is spilled on the unit, shut it off immediately and take it to a dealer for service.

Disconnect the unit during storms to prevent damage.

Electromagnetic Compatibility

Operation is subject to the following conditions: •This device may not cause harmful interference.

•This device must accept any interference received, including interfer- ence that may cause undesired operation.

•Use only shielded interconnecting cables.

•Operation of this unit within significant electromagnetic fields should be avoided.

Warning

For your protection, please read the following:

Water and Moisture: Appliances should not be used near water (e.g. near a bathtub, washbowl, kitchen sink, laundry tub, in a wet basement, or near a swimming pool, etc.) Care should be taken so that objects do not fall and liquids are not spilled into the enclosure through openings.

Power Sources: The appliance should be connected to a power supply only of the type described in the operating instructions or as marked on the appliance.

Grounding or Polarization: Precautions should be taken so that the grounding or polarization means of an appliance is not defeated.

Power Cord Protection: Power supply cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against them, paying particular attention to cords at plugs, convenience receptacles, and the point where they exit from the appliance.

Servicing: To reduce the risk of fire or electrical shock, the user should not attempt to service the appliance beyond that described in the operating instructions. All other servicing should be referred to qualified service personnel.

For units equipped with externally accessible fuse recepta-

cle: Replace fuse with same type and rating only.

Image 2
Contents Page Electromagnetic Compatibility Declaration of Conformity Table of Contents Ntroduction Congratulations Ncluded Items Section ONE Introduction Guided Tour of the GS30 Front PanelPage Page Rear Panel Getting Started Making ConnectionsPage Section TWO About the GS30 Performance ModeSelecting a Preset Footswitches Accessing the Tuner Learn-A-Lick/Jam-A-Long Our record time is used User Interface Section Three Edit ModeEditing a Preset Page Page Wah Modulation Depth Delay Level Amp Gain Modulation Level Expression Pedal AssignmentsPage Storing/Copying a Preset Section Four Effects Definitions Musical historyPage Page Page Parameter Definitions Creating a Preset Section Five TutorialPage Page Ongratulations! You have successfully created a new Preset Calibrating the Expression Pedal Resetting the GS30Section SIX Other Stuff Maintenance and Service Warranty Section Seven AppendixSpecifications Eadphone Output Impedance 10 ohms