Robo Start Instructions, Troubleshooting, General

ROBO START INSTRUCTIONS:

IN SINGLE-AUTO CUE MODE:

Use ROBO START(26) in SINGLE-AUTO CUE MODE(18) to alternate play between the CDX-04’s two CD players (one track from one side, then one from the other). In SINGLE-AUTO CUE MODE(18) play starts immediately with no blank or “dead” space. ROBO START(26) causes one side of the CD player to play when the other side is paused.

1.Engage SINGLE AUTO CUE MODE(18) with the SINGLE(18) button.

2.Press the ROBO START(26) button to activate ROBO START. Play will alternate between the two CD players. At the end of a track, the playing side pauses and the other CD deck plays a track. At the end of this track, the playing side pauses and the first deck resumes play.

IN CONTINUOUS MODE OR DURING NORMAL PLAY:

If you use the ROBO START(26) function without SINGLE-AUTO CUE MODE (in CONTINUOUS MODE or during normal play), CD deck does not alternate automatically. The PLAY/PAUSE(12) button must be pressed on the playing deck for the second track to play.

1.During normal play, set a CUE POINT on the other side of the CD player.

2.Press the ROBO START (26) button to activate ROBO START (the button will blink).

3.Press PLAY/PAUSE (12) button on the playing side to begin play from the cue point on the other side.

NOTE: IF PAUSED DURING PLAYBACK, IN THE MIDDLE OF A TRACK. WHEN THAT TRACK ENDS, PLAY WILL BEGIN FROM THE MIDDLE OF THE TRACK WHERE PLAY WAS

PAUSED.

TROUBLESHOOTING:

•If the disk will not play, check to see if the disc was loaded correctly (label side up). Also, check the disc for excessive dirt, scratches, etc.

•If the disc turns but there is no sound, check the cable connections. If they are okay, check your amplifier or receiver.

•If the CD skips, check the CD for dirt or scratches. Do not assume that the CD player is defective. CDs that are recorded improperly tend to skip on most or all CD players. Before sending the unit in for repair playa CD that you are sure plays properly.

SPECIFICATIONS:

GENERAL:
Type	........Compact Disc Player
Disc Type	Standard Compact discs (12 cm & 8 cm)
Time Display	Track Elapsed, Track Remain, or Total remain
Variable Pitch	.± 4, 8 ,16 %Slider with Resume Switch
Pitch Bend	± 4% Maximum
Instant Start	Within 0.03 seconds
Track Selection	1 to 99 Tracks
Installation	19" each
Dimensions	19" x 3.5" x 10"
Weight entire Unit	13.69 lbs. (6.21 kg)
AUDIO SECTION:
Quantization	1 Bit Linear/Channel, 3 Beam Laser
Oversampling Rate	8 Times
Sampling Frequency	44.1 kHz
Frequency Response	20 Hz to 20 kHz
Digital Output	IEC958
Total Harmonic Distortion	Less Than 0.05%
Signal to Noise Ratio	85~86 dB
Dynamic Range	85~90 dB
Channel Separation	85~86 dB
Output Level	2.0 +/- 0.2 V R.M.S.
Power Supply	AC 115/230V, 60/50 Hz

SPECIFICATIONS AND DESIGN ARE SUBJECT TO CHANGE WITHOUT NOTICE FOR PURPOSE OF IMPROVEMENT.

IN THE USA: IF YOU EXPERIENCE PROBLEMS WITH THIS UNIT, PLEASE CALL 1 (732) 738-9003 FOR GEMINI CUSTOMER SERVICE. DO NOT ATTEMPT TO RETURN THIS EQUIPMENT TO YOUR DEALER.

(6)