Behringer MX2442A manual Modifications, Aux send pre-EQ modification on mono channels

Page 21

EURODESK MX2442A

10. MODIFICATIONS

The following modifications require some knowledge in soldering. Only attempt that if you are experienced in using an iron on PCBs. Otherwise, refer to qualified personnel. After modification the BEHRINGER warranty becomes discretionary.

Links should not be threaded into holes on the PCB. They should be soldered to the tinned areas around the holes, and bowed slightly upwards in between.

Aux sends 1/2 > pre-EQ

All channel aux sends are post-EQ. If you want to convert them, carry out the modification described below to each channel. The right PCB area is indicated by a yellow printing (see figures below).

1)Disconnect power supply.

2)Cut the “post” track.

3)Add in a “pre” link.

4)Repeat for all channels you want to be modified.

Fig. 10.1: Aux send > pre-EQ modification on mono channels

Fig. 10.2: Aux send > pre-EQ modification on stereo channels

10. MODIFCATIONS

21

Page 20 Page 22
Image 21
Page 20 Page 22
Contents Eurodesk Detailed Safety Instructions Safety InstructionsForeword Eurodesk Table of Contents Eurodesk Overview ManualMetering Power Supply Unit PSU Input Level SettingMono Input Channels Equalizer Aux SendsRouting & Muting Stereo Input Channels Subgroups and Inserts SubgroupsInsert Points Inserting an external EQ/dynamics processor post channel EQ Aux Masters Main SectionHeadphones Monitoring2-Track In- and Output Connections TalkbackEurodesk MX2442A Back Panel/Serial Number Audio Connections Eurodesk MX2442A Patchfield and Plug Wiring SchemeDifferent plug types Initializing Channels for Gain Setting Setting UPAuditioning a Signal and Setting Up a Channel Selecting InputsMixing Topics Desk NormalizationEqualization Gain Optimization Aux send pre-EQ modification on mono channels ModificationsSpecifications § 1 Warranty CARD/ONLINE Registration § 2 Warranty Warranty
Top Page Image Contents