6Editing Programs
To Edit a Selected Program
1. Select a program to edit using the foot pedals or VALUE knob.
2. Turn the EFFECT knob to the effect module or parameter you wish to modify.
3. | Turn the VALUE knob to select | 2 |
| ||
| an effect type or value for the | 4 |
| module. As soon as you change | |
|
| |
| the value, the EDITED decimal |
|
| point on the display lights up to |
|
| show you a change has been |
|
| made to the current program. |
|
4. If the module has a parameter
such as DRIVE or PARAM,
1 turn the EFFECT knob to
select the parameter.
1 
3
5
5.Using the VALUE knob, select a value for the parameter.
6.Continue in this way until you have completed assignments for all modules and parameters.
To Restore Factory Presets
Once you have saved changes to a preset program, you can still recall the original settings. To enter RESTORE FACTORY PRESETS mode, simply hold down the VALUE knob as you turn the unit on and then select the program to
be restored (or 
for all programs). Press the VALUE knob to confirm your selection. Any program changes you have made will be lost, so you might want to copy the program to another location first. See chapter 8 for instructions on copying programs.
To toggle an effect module on and off, press both pedals while the effect module is selected.
Just turn the EFFECT knob to exit the
RESTORE FACTORY PRESETS mode, or turn the unit off and then on again.
19