Introduction 1
Effect Modules
If you were to think of the BassFX as a series of individual pedals linked together, then each pedal in that series would be considered an effect module. The BassFX has nine separate effect modules, as shown below:
You can assign one effect to each of these modules and adjust its parameters accordingly. On the face of the unit, you’ll see a list of possible effect types for some of these modules. For more on effect modules, see chapter 10.
Effect Types
When we use the word “effect” in this manual, we’re usually referring to an effect type. Each module provides you with a selection of effect types, only one of which may be chosen for each module. For example, the DIST module allows you to select which type of distortion you want (SS CLEAN, TUBE CLEAN, CLASSIC 1 and others). The behavior of each of these effect types may be adjusted in one or more ways to produce variations of the effect.
Parameters
A parameter is a control that changes the characteristics of an effect. When we use the word “parameter,” we are referring to the “direct control” parameter available to the DIST, FX1, FX2 and FX3 modules. DIST’s parameter is called DRIVE, and the parameters for FX1, FX2 and FX3 are labeled PARAM. The characteristic controlled by a parameter varies from effect to effect.
Programs
A program is a combination of effects modules 
and their respective settings. In PLAY mode, you 
have quick access to the BassFX’s 40 programs via the 
foot pedals and the VALUE knob. The programs are 
divided up into banks A – D and are identified by a bank 
letter and a program number on the display.
5