Nilfisk-ALTO AMX-120 user manual Ready to START?

Page 7

3.READY TO START?

3.1Please check the AC voltage available in your country before connecting your AMX-120 to the AC socket.

3.2Be sure that the main power switch is turned off before connecting the mixer to the AC socket. Also, you should make sure that all Input and output controls are turned down. This will avoid damages to your speakers and avoid excessive noise.

3.3Before turning on the AMX-120 you shall connect it to a power amplifier and turn-on the mixer BEFORE the power amplifier. Once you have finished your working session you shall turn the mixer off AFTER the power amplifier.

3.4Before disconnecting the AMX-120 always turn-off the power switch.

3.5Do not use solvents to clean your AMX-120. A dry and clean cloth will be OK.

Image 7

Contents AMX-120 External Connection Safety Related SymbolsImportant Safety Instructions Power SupplyPreface Table of Contents Introduction Features Ready to START? MIC Control ElementsBands Equalizer Input Level SettingMono MIC/LINE Channels LOW CUT ButtonPeak LED LOWPhantom LED Power LEDTape OUT TapePhones Rear Panel Description Power ON/OFF SwitchPhantom ON/OFF Switch AC Input ConnectorInstallation and Connection In-line Connection Audio ConnectionModification on mono and stereo channels For the Experts WHO Want to Know MoreTrack Block DiagramsTechnical Specification Terms and Conditions WarrantyWarranty Registration Card Return NoticeSeikaku Technical Group Limited