Atlas Sound ECM-RACEWY6, 1, ECM-20M, ECM-30 Activating an ECM via ECS-6RM Relay Contacts, Example

Page 14

ECM-RACEWY

Owner’s Manual

ECM-20, ECM-20M, & ECM-30

 

 

 

Activating an ECM via ECS-6RM Relay Contacts

Each Channel of the ECS-6RM also has a Relay contact that works in conjunction with the ECM control port. Sequencing and timing of these connections are the same as the corresponding ECM channels. Example: Sequence 1 ECM Port output works at the same times CH 1 Relay contact. Note: All ECM modules can be trigger using the Relay contacts to activate the ECM module. See ECM module for details.

ECS-6RM Wiring Configuration

Example 1

ECS-6RM wired to six ECM-20 or ECM-20M Modules.

Example 2

ECS-6RM wired to four ECM-20 or ECM-20M Modules in the ECM-RACEWY6 and two separate ECM-15SH and ECM-20SH housings.

1601 Jack McKay Blvd. • Ennis, Texas 75119 U.S.A.

Telephone: 800.876.3333 • Fax: 800.765.3435

AtlasSound.com

– 14 –

Specifications are subject to change without notice.

Image 14
Contents ECM-RACEWY6/3/1 Table of Contents Important Safety Instructions ECM-RACEWY Introduction Applications ECM-RACEWY Key FeaturesECM Module Key Features Raceway ECM Housing Raceway AC Inlet KnockoutsRaceway Mounting Rails Raceway DimensionsRaceway AC Ground Stud Trigger/Status Port Pin Identification External Trigger/Manual On SwitchAC Fault LED Incoming AC LEDECM-30 Front Panel Features Trigger/Status Port Pin IdentificationDifferences Between the ECM-20 & ECM-20M Modules Internal Features of the ECM ModulesECM Electrical Control Modules ECM-3BP Module Blank Cover Plate ECM-ACIN Wire KitWiring the ECM Control Modules Example 2 Dual 20A AC Line 40A ECM-20/ECM-20M Module System Wiring ConfigurationExample 1 Single 20A AC Line Example ECS-6RM Wiring ConfigurationActivating an ECM via ECS-6RM Relay Contacts ECM Data Wire and Distance Action Needed ECM TroubleshootingPossible Cause ECM-RACEWY Specifications MechanicalFront Panel ECM-20/ECM-20M SpecificationsTechnical Data ECM-30 Specifications Limited Warranty Service