Multiquip manual MT-76D2TAMPING Rammer Initial START-UP, Engine

MT-76D2TAMPING RAMMER — INITIAL START-UP

This section is intended to assist the operator with the initial start-up of the MT-76D2Tamping Rammer.It extremely important that this section be read carefully before attempting to operate the rammer.

DO NOT use your rammer until this section is thoroughly understood.

CAUTION Read Manual

Failure to understand the operation of the MT-76D2Tamping Rammer could result in severe damage to the rammer or cause personal injury.

Rammer Gearbox and Spring Cylinder

This unit uses an oil bath lubrication system. Check oil level through oil level sight glass at rear of tamper foot. If oil is not visible, add #10W-30 motor oil. Oil bath contains approx. 1.7 pt. (800cc).

Engine

1. Fill the fuel tank with automobile diesel fuel (See Figure 3).

Figure 4. Oil Level

INSPECTION

1.Check all nuts, bolts and fasteners for tightness. Retighten as necessary.

2.Clean dirt from the recoil starter and foot. Wipe entire unit clean before operating.

3.Replace any missing or damaged Safety/Operation decals.

Figure 3. Fuel Tank

2.For checking the oil level, move the engine to vertical position and check that the oil is level with the oil inlet (about 700cc). See Figure 4.

MT-76D2 TAMPING RAMMER —OPERATION AND PARTS MANUAL — REV. #5(11/08/07) — PAGE 15