INSTALLATION REGULATIONS AND REQUIREMENTS
In the interests of both the Law and of Safety, this appliance must only be installed by a competent person in accordance with the current Gas Safety (Installation and Use) Regulations or the rules in force and the manufacturer’s instructions. Note: Failure to install a gas appliance correctly could lead to prosecution.
The following are the relevant Codes of Practice and British Standards.
The Building Regulations issued by the Department of the Environment.
The Building Standards (Scotland)(Consolidation) Regulations issued by the Scottish Development Department.
BS 83O3 1986 | BS 544O Pt1 199O | BS 544O Pt2 1989 | ||
BS 1251 1987 | BS 5871 Pt2 1991 |
| BS 7566 Pt | |
BS 6891 1988 | BS 6461 Pt1 | 1984 |
|
|
BS 715 1993 | BS 1289 Pt1 | 1986 | & 1975 |
|
FIRE SURROUND AND OPENING REQUIREMENTS
Check that the chimney and flue structure are sound and conform to the following flue requirements:
a)A conventional brick or stone chimney with a minimum effective
b)A twin walled metal flue box manufactured to BS 715 with a 125mm diameter insulated flue with a minimum effective height of 3 metres. See page 6.
c)A
Dampers, register plates or incorrect flue terminals, must not restrict any of the above flues. The flue must only service a single appliance and not have any branches or traps which may impede the natural draught, any flue damper or restrictor must be removed or fixed in the fully open position.
The front and base of the fire opening must be flat and square to ensure a good seal with the appliance; this is to ensure that there is no reduction in draught that may cause spillage to occur.
CONTENTS CHECK LIST
Fire Box Assembly c/w
Burner Assembly
Glass Panel
Flue Restrictor
Blanking Plate & Gasket
Ceramic Components Fibre Back panel
L & R Hand Side Cheeks Simulated Coal front Coal Support Shelf
10 Large Coals
3 Small Coals
Components
Fender
Ash Pan Cover
L & R Hand Side Covers
Canopy
Spacer Frame
Fixing Kit
6 Plastic Wall Plugs
4 No 10 x 1 1/4" Round Hd Woodscrews
4
2 No 8 x 1" Round Hd Woodscrews
2 No 8 x 1/2" Self Tap Screws
2 Penny Washers
4 M4 x 12 Pan Hd Machine Screws
1 8mm Equal End Coupling
2 M4 Wing Screws
1 Cable Fixing Kit
Bundy Pipe for Concealed Fitting Bundy Pipe for RH Gas Supply 8mm x 8mm Inline Connector Installation & Servicing Instructions Users Instructions
Brass Knob Kit
Page 3