Ignition System:
The BISTRO is operated with an electronic battery operated ignition system.
If, at any time when lighting the gas grill, a sparking sound is not heard it could be that the battery requires replacing.
If the battery has been replaced and spark is still not present, check all wiring and spark electrode for breakage or corrosion (see “Troubleshooting”).
�������
Battery Removal:
Unscrew ignitor button and remove battery.
To remove the battery, unscrew the ignitor button located on the | ������� ������� ������ | ||||||
control panel front. Remove ignitor button and pull spring out of | |||||||
ignitor body; the “AA” will come out with the spring attached (refer | ��� ������ �������� |
|
|
|
|
|
|
|
|
|
| ||||
| |||||||
to Figure 33). |
|
|
|
|
|
|
|
Replace the battery and install in the reverse order.
Ignitor Module Removal: | Figure 33 |
|
Undo the two (2) # 8 sheet metal screws and drop ignitor module straight down.
When removing the ignitor module from under the control panel, first remove the two 1⁄4” stainless steel sheet metal screws and drop the module and the heat shield straight down (as shown in Figure 34). Remove one of the short wires that comes from the ignition module that is connected to ground. Install any new wires where the shorted wire was removed from the ignition module for the extra components that could be added to the BISTRO.
NOTE: When installing the ignitor module and the heat shield, please take special care not to damage any of the wires as failure in the ignition system could occur.
Figure 34 |
|
|
|
���� ����� �� ����� ������ | ���� ������ ����� �� | ���� ������ | |
������� �� ������� ������ | ����� ����������� | ��������� | |
� |
| 3 |
|
|
|
| |
� | 4 | 2 |
|
|
|
| |
|
| ������� ������ |
|
Figure 35
19