Enviro C-10124 guide

ENGINE INSTALLED ONTO CART ASSEMBLY:

Components Required:
● Rolling cart	● Pre-assembled engine	● (4) 1⁄4” x 1⁄2” stainless steel bolts
● (4) 1⁄4” stainless steel lock washers	● Metal Foil Container	● Drip tray

WARNING: Two (2) people are required to lift the engine onto the cart safely.

Empty all the components (frame deflectors, manual bag, and warming tray) from inside the engine to make it lighter to lift. Turn the cart body right side up. Using two (2) people, lift the engine onto the cart. Take care to line up the manifold fitting on the bottom of the engine with its corresponding cut away on the top of the cart. Refer to Figure 17.

��

��
��
��
��
��	��
	��
	��
��

Figure 17

Attach the engine to the cart with four (4) bolts and four lock-washers. The bolts go from inside the cart through the top of the cart into pre-threaded inserts already installed in the bottom of the engine. Using a 5/32” Allen key tighten all four (4) bolts.

The metal foil container can be installed at any stage but is pointed out in this step to provide clarity on the location for installation. If installing at a later time, open cabinet and slide container into place.

Components Required:

● Rolling cart

● Pre-assembled engine