Safety Precautions

Please read these instructions before assembling or operating this outdoor cooking appliance.

The ENVIRO BISTRO is designed for outdoor use only.

The ENVIRO gas barbecue must be installed and operated in accordance with the installation requirements of your local gas supply authority or the appropriate installation code in the area of installation. In the absence of local codes, use either the National Fuel Gas code, ANSI Z223.1, or CAN/CGA-B149.1, National gas Code or CAN/CGA- B149.2, Propane Gas Code.

If an external electrical source is utilized, this gas grill, when installed, must be electrically grounded in accordance with the local codes or, in the absence of local codes, with the National Electrical Code, ANSI/NFPA 70, or the Canadian Electrical Code, CSA C22.1.

Keep electrical cord and the fuel source hose away from any heated areas.

This outdoor gas grill is not intended for use in or on recreational vehicles and or boats. Operate this gas grill only in areas free of obstructions for combustion and ventilation air.

The exterior surfaces of this gas grill can become very hot when in use. Exercise caution. Use protective gloves and/or pot holders.

DO NOT USE THIS APPLIANCE IN AN ENCLOSED AREA.

Examples of enclosed areas are garages, sheds or enclosed sundecks or any other enclosed areas. Do not use this gas grill under overhead, unprotected combustible materials such as awnings or umbrellas.

KEEP CHILDREN AWAY.

Do not allow children to operate this appliance. Keep children and pets away from barbecue during use.

CHECK FOR GAS LEAKS.

Once the barbecue has been assembled and installed, make sure the gas knobs and valves are in the “OFF” position. Turn gas “ON” at the source. Use a small brush to apply a warm soapy water solution to all gas connections (use a half dish soap and half warm water). If a gas leak is present, bubbling will occur. Gas leaks can be repaired by using an approved pipe thread sealant or approved Teflon tape. The flexible gas hose must be inspected before each use.

NEVER USE AN OPEN FLAME WHEN TESTING FOR LEAKS.

LPG GAS CYLINDER.
An approved 20 lb. gas cylinder is required for optimum performance and
convenience.
LPG gas cylinder is not provided with this appliance. When purchasing a
LPG cylinder, make sure the cylinder has a manual shut off valve and that
the cylinder has a collar to protect the manual shut off valve.
LPG gas cylinder must be constructed and marked in accordance with
specifications of the U.S. Department of Transport (DOT). In Canada gas
cylinders must meet Canadian Transportation and Communications (CTC)
specifications.
Lift the LPG cylinder by its collar, never from the valve.	Figure 1
NEVER CONNECT AN UNREGULATED LP GAS CYLINDER TO YOUR BARBECUE.
DO NOT SUBJECT LP GAS CYLINDERS TO EXCESSIVE HEAT.

WHEN THE APPLIANCE IS NOT IN USE, THE GAS SUPPLY SYSTEM MUST BE TURNED “OFF” AT THE SOURCE.

KEEP APPLIANCE AWAY FROM ANY COMBUSTIBLE MATERIALS.

VISUALLY INSPECT THE RUBBER GAS HOSE AND CONNECTIONS AND BURNERS ON A REGULAR BASIS TO ENSURE NO DAMAGE OR DETERIORATION IS PRESENT.