Enviro 50-1628 owner manual Check burner for proper operation

Maintenance And Service

To install the burner:

1.Insert the mixing tube into the mixing tube box (refer to Figure 8 or 9).

2.When the burner is resting in the firebox ensure that the front edge of the burner is lined up with the front lip of the firebox (see Figure 10 or 11).

3.Re-install the log set or rock set

(see SECONDARY INSTALATION - LOG SET INSTALLATION or SECONDARY INSTALATION - ROCK SET INSTALLATION) and the door.

4.Check burner for proper operation.

FIREBOX BAFFLE REMOVAL:

Figure 10: Align Log Set Burner With Firebox.

Figure 11: Align Rock Set Burner With Firebox.

The firebox baffle can be remove when cleaning the venting pipe.

1.Remove the glass door as shown in the MAINTENANCE AND SERVICE - GLASS DOOR REMOVAL.

2.Remove the two (2) Torx T-20 screws holding the front of the firebox baffle in place (refer to Figure

12). IMPORTANT: The baffle should be held in place when the screws are removed to prevent it from falling, which could damage the firebox liner, log set, or rock set.

3.Carefully push the back of the baffle up while pulling the front down (see A’s in Figure 13) then pull the baffle out of the firebox.

4.Re-install the firebox baffle and the door when done.

Figure 12: Firebox Baffle Screws Removal. Figure 13: Firebox Baffle Removal.

11