Vermont Casting VCS5017 user manual Assembly Procedures, Unpack Carton and Verify Contents

Page 19

VCS4007 / VCS4017 / VCS4027 / VCS4037

VCS5007 / VCS5017 / VCS5027 / VCS5037

ASSEMBLY PROCEDURES

Tools Required: knife or scissors, Phillips or Robertson (square head) screwdriver..

Model VCS4007

Shown

Step 1: Unpack Carton and Verify Contents

Use a sharp cutting tool to cut the straps on the packaging and then lift off the carton top. The sleeve surrounding the barbecue can be removed by lifting it straight up and over the top of the unit. Compare all contents to the parts list that accompanies this assembly manual. Next, remove the protective plastic coverings from the metal parts. Be careful not to scratch or damage the finish of the metal parts when removing the protective plastic. Refer to the parts list for fastener detail.

CAUTION: Some parts may have sharp edges; to avoid injury, wearing gloves during assembly is strongly recommended

Page 1

50004062 11/06 Rev.0 En

Image 19

Contents USER’S Manual for Models Page Signal Words Safe Locations for USE of this Outdoor Grill Safe USE of Natural GAS Safe USE of LP Propane GASPrevention of Burns Electrical SafetyFuels Additional Warnings Safety Gas Hookup For Your Safety LP Propane GAS Supply ConnectionTo Disconnect Natural GAS Supply Connection To ConnectActivating the Igniter Electronic Ignition System Control Functions Propane Tank ValveLighting the Main Burners FLARE-UPS Turning the Burners OFFMatch Lighting the Main Burners Match Lighting the Rotisserie Burner To Start the Rotisserie BurnerRotisserie Setup if equipped Shutting the Burner OFF Lighting the Side Burner if equippedTroubleshooting Guide Troubleshooting Guide Unpack Carton and Verify Contents Assembly ProceduresInstall U-Clip Fasteners Parts Required Install the CastersAttach Shelves Parts Required Install the Side Shelf Supports Parts RequiredSecure Side Shelf to Grill Parts Required Secure Shelves Parts RequiredSecure Condiment Tray to Console Parts Required Attach Knobs Parts Required Attach Side Burner Lid S/B-Single Parts RequiredRemove the Packing Tape Attach the Handle to the Door Parts Required Install the Grease Cup and Grease Pan Parts RequiredAttach Stabilizer Bracket Parts Required Install the Battery Install the Internal Components Parts RequiredInstall the LP Cylinder LP Models Only Parts Required