Vermont Casting VCS5017 user manual Prevention of Burns, Electrical Safety

Page 6

Safety

Always promptly shut off the gas supply and immediately extinguish all flames if you smell gas. Always seek assistance from your gas supplier or local Fire Department if the gas smell persists, because of the danger of fire or explosion.

Always confirm that there are no gas leaks before lighting this Grill. Apply a 50/50 solution of liquid soap and water to the gas supply line connectors with a brush or spray bottle, and watch for bubbles. Never use a match or open flame to test for gas leaks.

Always visually inspect the gas supply line for fraying, cracking or rodent damage before each use of this Grill and, if necessary, install a replacement before lighting this Grill.

Never permit a gas supply line to contact any heated surface of this Grill.

Ensure the Grill is properly cooled before placing the cover back on the Grill.

D. PREVENTION OF BURNS

Always keep children and pets under close supervision when using this Grill, and never permit them to come near the Grill while it is in use, as the exterior surfaces will be very hot.

Always wear insulated protective mitts when working at the Grill, or when attempting to close a gas supply valve after cooking has been completed, to prevent possible burns. Always use insulated pot holders when handling containers of hot food.

Always wear an insulated protective mitt when adding a smoking agent to a Smoker Box.

Never store or use gasoline or other flammable or volatile substances in the vicinity of this Grill, or in the vicinity of any other heat-generating appliance.

E. ELECTRICAL SAFETY

Always confirm that this Grill has been grounded in accordance with local Codes or, in the absence of local Codes, with the National Electrical Code, ANSI/NFPA No. 70 or the Canadian Electrical Code, CSA C22.1, when an external electrical source is being utilized for the Rotisserie Motor.

Always use a grounded three-prong outlet and a three-prong extension cord to energize the Rotisserie Motor. Never alter or remove the grounding prong on the Rotisserie Power Cord, as an electric shock hazard would then result.

Never permit an electrical supply cord to contact any heated surface of this Grill.

Page v

Image 6
Contents USER’S Manual for Models Page Signal Words Safe Locations for USE of this Outdoor Grill Safe USE of LP Propane GAS Safe USE of Natural GASElectrical Safety Prevention of BurnsFuels Additional Warnings Safety For Your Safety LP Propane GAS Supply Connection Gas HookupNatural GAS Supply Connection To Connect To DisconnectControl Functions Propane Tank Valve Activating the Igniter Electronic Ignition SystemLighting the Main Burners Turning the Burners OFF FLARE-UPSMatch Lighting the Main Burners To Start the Rotisserie Burner Match Lighting the Rotisserie BurnerRotisserie Setup if equipped Lighting the Side Burner if equipped Shutting the Burner OFFTroubleshooting Guide Troubleshooting Guide Assembly Procedures Unpack Carton and Verify ContentsInstall the Casters Install U-Clip Fasteners Parts RequiredInstall the Side Shelf Supports Parts Required Attach Shelves Parts RequiredSecure Shelves Parts Required Secure Side Shelf to Grill Parts RequiredSecure Condiment Tray to Console Parts Required Attach Side Burner Lid S/B-Single Parts Required Attach Knobs Parts RequiredRemove the Packing Tape Install the Grease Cup and Grease Pan Parts Required Attach the Handle to the Door Parts RequiredAttach Stabilizer Bracket Parts Required Install the Internal Components Parts Required Install the BatteryInstall the LP Cylinder LP Models Only Parts Required