Basic Specifications, GAS Connection | Viking TruSearTM specs

BASIC SPECIFICATIONS

Description	VGIB151T		VGIB242T
Description	VGIB151T		VGIB242T
Overall Width	15-5/16” (38.9 cm)		26 1/4” (66.7 cm)
Overall Depth
To end of landing ledge		31-9/16” (80.2 cm)
To end of knobs		32-5/8” (82.9 cm)
Overall Height		10 1/2” (26.3 cm)
Cutout Width	14” (35.6 cm)		24 3/4” (62.9 cm)
Cutout Depth		27-1/2” (69.9 cm)
Cutout Height		10-1/4” (26.0 cm)
Gas	Natural:	standard residential 1/2” (1.3 cm) ID gas service line.
Requirements	LP/Propane:	equipped with high capacity hose/regulator assembly for
		connection to standard 5gal, 20 lb. LP/Propane gas cylinder
		with Type 1, QCC-1 connection or standard residential 1/2”
		(1.3 cm) ID gas service line.
Infrared Burner		21,500 BTU Nat./20,000 BTU LP
Rating		(6.3 kW Nat./5.9 kW LP)
Approximate Shipping	55 lbs. (24.8 kg)		160 lbs. (72.0 kg)
Weight

GAS CONNECTION

Verify the type of gas supply to be used, either natural or LP, and make sure the marking on the rating plate agrees with that of the supply. Never connect an unregulated gas line to the appliance. An installer supplied gas shut- off valve must be installed in an easily accessible location. All installer supplied parts must conform to local codes, or in the absence of local codes, with the National electrical Code, ANSI/NFPA 70 and the National Fuel Code, ANSI Z223.1. In Canada: Installation must be in accordance with the current CAN/CGA-B149.1, Natural Gas Installation Code or CAN/CGA-B149.2, Propane Installation Code and/or local codes. All pipe sealants must be an approved type and resistant to the actions of LP gas. Never use pipe sealant on flare fittings. All gas connections should be made by a competent technician and in accordance with local codes and or ordinances. In the absence of codes, the installation must comply with the National Fuel Gas Code ANSI Z223.1.

The gas burner and its individual shut-off valve must be disconnected from the gas supply piping system during any pressure testing of that system at test pressures in excess of 1/2 PSIG (3.5 kPa). The unit must be isolated from the gas supply piping system by closing its individual manual shut-off valve during any pressure testing of that system at test pressures equal to or less than 1/2 psi (3.5 kPa).

BURNER ADJUSTMENT

There is no burner adjustment for the infrared burner. Once heated, the flames should glow a bright red color.

1/4”

(.64 cm)

Orifice	FLAME HEIGHT
	TruSear BURNER