GRILL MOVING AND STORAGE
·Do not store the Grill unless it has cooled down and has been cleaned.
·Always Lock the Grill Hood with the Strap Lock before moving and storing this Grill.
·To avoid possible injury, be careful when rolling your grill so it does not roll up against you.
Your Gas Grill comes with convenient wheels and a slide out handle for
·Disconnect the LP cylinder from the regulator.
·Fold and strap the Grill side tables over the closed Hood.
·Slide the Left Handle Bar back under the grill.
·Remove the leg shelf. Release the locking springs and lower the left end of the Leg Shelf. Lift the other end off the mounting Hooks on the right legs.
·Swing the Gas Regulator up into its storage position behind the front panel of the Grill and clip it into place.
(FIG. 24)
·Fold Legs to locked position under Grill.
·Store Leg Shelf back in the bottom of the grill and snap into place.
·Grasp the Right side Handle Bar; lift Grill on wheels and roll the grill away to storage area. (FIG. 25) DO NOT
ATTEMPT TO CARRY THE GRILL BY GRASPING THE HOOD HANDLE
Store Gas Regulator & Hose
Fig. 24
Storage Clip
Use Slide Handle
Bar for Towing
For Convenient Storage
Fig. 25
TROUBLESHOOTING
Problem
Burner will not light using the ignitor
Possible Cause | Solution |
Not pausing long enough | When lighting the Burner, push in and turn the Control Knob |
before clicking the Igniter | counterclockwise to “I” when you feel resistance. Pause 4 |
| seconds, then push in and turn the Control Knob until a click is |
| heard. |
No spark | The spacing between electrode and Burner ports should be |
| approximately 3/16”. Make sure wire connections are secure |
| and burner is attached securely to brackets. |
LP gas cylinder is empty | Dispose of empty cylinder and replace with a full one. |
Excess flow valve tripped in | Turn Control Knob to “OFF” position. Wait five minutes. Relight |
Regulator | LP gas grill. If flame remains to be low, turn off gas. |
| Disconnect the Lp gas cylinder from the Regulator. Reconnect |
| the LP gas cylinder to the Regulator. Perform a leak test. |
| Relight grill. This will reset the excess flow valve. |
Obstructions in burner
Electrode and burner are wet
Wire is loose or disconnect-
Wire is shorting (sparking between ignitor wire and electrode
Burner not assembled correctly
Clean burner (See Burner Maintenance in Care and Maintenance section of this manual)
Dry electrode with clean cloth
Reconnect the wire
Replace ignitor wire/electrode assembly (Call the Customer Service Department @
See Assembly Instructions for installing the Burner.
13