Meco 67A4T09K21 manual Storage

Page 29

29

Storage

!WARNING

To reduce the risk of serious bodily injury or death:

Store your LP gas grill in a cool dry place. Do not store an LP Gas Cylinder in a space greater than 125 degrees Fahrenheit. Never store a connected LP Gas Cylinder in a building, garage, or any enclosed area.

Store LP Gas Cylinders outdoors out of reach of children.

Never store an LP Gas Cylinder indoors (empty or filled) unless it is disconnected from the gas grill and the cylinder’s Gas Supply is turned “OFF.”

Never leave a LP Gas Cylinder inside a vehicle that can become overheated by the sun.

Even though your LP Gas Cylinder may appear to be empty, gas may still be present and the LP Gas Cylinder should be transported and stored accordingly.

Never store a spare LP Gas Cylinder under or near the LP gas grill.

Always turn off the LP Gas Cylinder at the LP Gas Cylinder valve when the gas grill is not in use.

1.Disconnect LP Gas Cylinder from grill and store outside, in a dry, well-ventilated area, away from any sources of heat or ignition. Re-cap LP Gas Cylinder valve with the Safety Cap.

2.Remove Burners and wrap with aluminum foil to prevent insects from entering the Burner holes. Store wrapped Burners on top of Cooking Grid.

3.You may wrap the Cooking Grid and Flavor Activators in aluminum foil and place inside the Hood or store inside your dwelling.

4.Place a grill cover over the grill and store outdoors if possible. It may be stored indoors only if the LP Gas Cylinder is disconnected from the gas grill and stored outside.

5.Before next use, remove aluminum foil and reinstall Burners, Flavor Activators, and Cooking Grids.

6.Before using the grill after periods of storage or non-use (i.e. over winter), check your LP gas grill for gas leaks, deterioration, proper assembly, and Burner obstructions.

7.Periodically check and tighten all nuts, bolts, and screws.

Image 29
Contents Sets Up In Minutes LP Gas Grill Assembly and Use ManualCarbon Monoxide Hazard Tools Required for AssemblyDescription Packing ListContents Preparation for Assembly Step Securing Cart Leg Frames Assembly InstructionsStep Wheel Assembly Step Cylinder Blocking Wire Assembly Step Steel Privacy Panel AssemblyStep Hood/Body To Cart Assembly Step Side Table Assembly Step Side Burner Igniter Wire Connection Step Side Burner Valve AssemblySide Burner Grid Assembly Step Side Burner Control Knob AssemblyStep Bottom Body Panel Assembly Foil Pan/Grease Pan AssemblyStep Battery in Igniter Installation Step Flavor Activator / Cooking Grid / Warming Rack AssemblyLP Gas Cylinder Connecting/Disconnecting the GasUsing Gas LP Hose and Regulator Connecting LP Gas CylinderDisconnecting LP Gas Cylinder Installation Codes Before Using Your LP Gas GrillSelecting a Location Performing a Leak TestHow to Perform a Leak Test First Time USE and as required Page Off position Lighting the Grill Using the Pulse-Spark IgnitorManual Lighting of the Grill on Manually Lighting the Grill Manually Lighting the Side Burner Lighting the Side BurnerCheck The Flame Manually Lighting the Side Burner Grill Cooking Direct Method Cooking On the Gas GrillIndirect Cooking Roasting Roasting Indirect MethodDirect Cooking on the Grids End of Cooking Session Warming RackCleaning the Grill Care and MaintenanceHow to Clean the Burners Open up Storage Emergencies TroubleshootingSee How to Clean Burners in Care and Maintenance Clean the Burners. See How to Clean Burners in CareMaintenance Important Notice This page intentionally left blank Parts Illustration Key Description Quantity Parts ListMeco Corporation Limited Warranty Limited Warranty