INSPECTION OF HOSES
1.Visually inspect all hoses prior to each use of th grill.
2. Remove the inspection panel located on the rear of column near the top by rotating the locking mechanism.
3.Lift the panel clear of the column.
4.Using a flashlight if necessary, inspect the gas delivery hose, and the upper end of the gas supply hose, from this area.
5.If either hose shows excessive wear, abrasion, cutting, or other damage, it must be replaced prior to using grill, (the valve and gas delivery hose is one assembly). Replace the hoses only with those specified by the manufacturer.
6.Open the access panel at the bottom rear of the column.
7.Using a flashlight if necessary, visually inspect the bottom end of the gas supply hose from this area.
8.If the hose shows excessive wear, abrasion, cutting, or other damage, it must be replaced prior to using the grill. Replace the hose only with one specified by the manufacture.
CONNECTING TO A RESIDENTIAL NATURAL GAS SUPPLY
1.Open the access panel at the bottom rear of the column.
2. Locate the Natural Gas inlet (3/8” 45º S.A.E. Male Flare fitting).
3.Guide a Natural Gas Supply Hose (not included)* through the rectangular opening at the bottom of the access panel.
4.Securely attach the female end of the Natural Gas Supply Hose to the male end of the fitting using a wrench. Do not overtighten.
5.Close access panel.
*Note: a Natural Gas Supply Hose is not included with your Del Mar since many residential applications are quite different. Natural Gas Supply Hoses may be purchased at your local Hardware Store or Home Improvement Center in a variety of sizes and lengths to accommodate your residential fittings.
7