MAINTENANCE
Stainless steel contrary to popular belief can rust. Most commonly, deposits on surface of the product will trap moisture. It is this moisture that robs stainless steel of oxygen. Oxygen is the element that reacts with stainless steel to form a protective layer of chrome oxide. Robbed of oxygen, this reaction does not take place and “crevice corrosion” or “surface rusting” occurs. To minimize this effect, thoroughly clean your grill with soap and water, rinse with fresh water, and dry. Avoid using stainless steel polishes on grill exterior as most leave a residue that may discolor when grill is heated.
Additionally, stainless steel that is exposed to high heat will change color and texture over time. The “amber” color of grill exterior and internal components is not a failure of the stainless steel and will not affect products operation. When this happens, we recommend using “Magma Magic” Grill Restorer to remove the “amber” color and return grill to its original luster. However, prolonged exposure to extreme high heat will cause chromium and nickel to “burn out” of stainless steel. At this point stainless steel will become more susceptible to corrosion and will start to deteriorate. We recommended replacement of internal components as they become seriously deteriorated.
We recommend thoroughly cleaning grill and internal components after each outing. Disassemble interior components and remove all food residue. Use a “Scotch Brite” pad or similar product and
Grill Grates - Clean with brass wire brush while grill is warm. Use Oven & Grill cleaner for
Ceramic Electrode - Located just beside the burner, it should be kept clean of grease and debris. Be careful not to damage the ceramic insulation or the wire. See page 5 for electrode spark adjustment.
Control Valve - All valves are set and tested at our factory. Do not attempt to adjust or disassemble the valve in any way. Call Magma if you suspect it is not adjusted properly. Clean valve with a cloth and remove any debris obstructing the orifice.
Repair/Replacement Parts - All replacement parts are readily available at your Magma Retailers or directly from Magma. For a complete list of replacement parts visit our website www.MagmaProducts.com.
USING GRILL WITH ON-BOARD LPG (PROPANE) SYSTEMS
• Magma |
Hose Kits allow Magma Grills to be installed |
within a boats existing |
low pressure LPG (Propane) system. |
• Use only Magma Type 3 Low Pressure |
LPG (Propane) Valves. See our Valve |
Application Guide at www. |
Gourmet Gas Grill
Gourmet
Gas Grill
Align valve stem key to valve chamber lock detent and rotate
Type 3 Valve
MagmaProducts.com for correct valve. |
• In North America use Magma |
LPG 10' Gas Grill Connection Kit in |
Typical Marine & R.V. Application
Gourmet Gas Grill
Type 3
Valve
conjunction with Type 3 Valve. Outside North America check your local dealer for proper hose and fittings.
•A primary shutoff valve (supplied with Gas Grill Connection Kit) must be used with this control valve at point of connection into your system. This allows shut off of gas supply to hose leading to grill.
Cylinder Valve |
|
|
Gauge | Solenoid |
|
| Shut off | To other LPG |
Gas Regulator valve | appliance | |
Propane (LPG) |
| or use cap |
|
| |
| ||
10' Gas Grill Connection Kit |
| |
6