Intel DG45ID manual Consumer IR CIR Headers, Front Panel CIR Receiver Input Header Signal Names

Intel Desktop Board DG45ID Product Guide

To install the cable that connects your front panel audio solution to the front panel audio header, follow these steps:

1.Observe the precautions in "Before You Begin" on page 27.

2.Turn off all peripheral devices connected to the computer. Turn off the computer and disconnect the AC power cord.

3.Remove the cover.

4.Install a correctly keyed and shielded front panel audio cable.

Consumer IR (CIR) Headers

The Desktop Board has two CIR headers: the receiver or input header (Figure 21, G) and the output or emitter header (Figure 21, D). The receiver header consists of a filtered translated infrared input compliant with Microsoft CIR specifications and a “learning” infrared input. The learning input is a high-pass input which the computer can use to “learn” to speak the infrared communication language of other user remotes. The emitter header consists of two output ports which the computer can use to emulate “learned” infrared commands in order to control external electronic hardware.

NOTE

The Consumer IR option must be enabled in the system BIOS before it can function. Press <F2> at boot to enter the system BIOS, and go to Advanced > Peripheral Configuration > Enhanced Consumer IR, and set this option to Enabled.

Table 8 shows the pin assignments for the front panel CIR receiver (input) header and Table 9 shows the pin assignments for the back panel CIR emitter (output) header.

Table 8. Front Panel CIR Receiver (Input) Header Signal Names

Pin	Signal Name
1	Ground

3No Connection

5+5 V Standby

7Key (no pin)

Pin	Signal Name
2	LED
4	Learn-In
6	Vcc
8	CIR Input

Table 9. Back Panel CIR Emitter (Output) Header Signal Names

Pin	Signal Name
1	Emitter Out 1
3	Ground
5	Jack Detect 1

Pin Signal Name

2Emitter Out 2

4Key (no pin)

6Jack Detect 2

46