cAuTioN
f
SPIDER ALERT!
If you notice thatyour grill is getting hard to light or thatthe
flame isn't as strong as it should be, take the time to check and clean the ventud's.
3.Remove carryover tubes and burners.
4.Detach electrode from burner.
NOTE: Removal/Detachment method will depend on the
burner configuration. See different configurations in illustrations below.
5.Carefully lift each burner up and away from valve openings. We suggest three ways to clean the burner tubes. Use the one easiest for you.
(A)Bend a stiff wire (a light weight coat hangerworks well)
into a small hook. Run the hook through each burner tube several times.
r.._.,_ _
| (B) Use a narrow bottle brush with a flexible handle (do not |
| use a brass wire brush), run the brush through each |
| burner tube several times. |
| (C) Wear eye protection: Use an air hose to force air into |
| the burner tube and out the burner ports. Check each |
| port to make sure air comes out each hole. |
6. | Wire brush entire outer surface of burner to remove food |
| residue and dirt. |
7. | Clean any blocked ports with a stiff wire such as an open |
CONTROLPANEL
SPIDERWEBS INSIDE VENTURI
paper clip. |
8. Check burner for damage, due to normal wear and corrosion |
!
BURNER
In someareasof the country,spidersor smallinsectshavebeen knownto create"flashback"problems.The spidersspinwebs,build nestsand layeggs inthe grill'sventuritube(s)obstructingthe flowof gasto the
Topreventflashbacksandensuregoodperformancethe burnerand venturiassemblyshouldbe removedfromthe grillandcleaned
eforeusewheneverthe grill hasbeenidlefor anextendedperiod,J j
Storing Your Grill
•Clean cooking grates.
•Store in dry location.
•When LP cylinder is connected to grill, store outdoors in a well- ventilated space and out of reach of children.
•Cover grill if stored outdoors. Choose from a variety of grill covers offered by manufacturers.
•Store grill indoors ONLY if LP cylinder is turned off and disconnected, removed from grill and stored outdoors.
•When removing grill from storage, follow "Cleaning the Burner
Assembly" instructions before starting grill. Cleaning the Burner Assembly
Follow these instructions to clean and/or replace parts of burner assembly or if you have trouble igniting grill.
1.Turn gas OFF at control knobs and LP cylinder,
2.Remove cooking grates and flame tamers.
some holes may become enlarged. If any large cracks or |
holes are found replace burner. |
VERY IMPORTANT:Burner tubes must reengage valve
| openings. See illustrations at right. |
|
9. | Attach electrode to burner. | Correct |
|
| |
10. | Carefully replace burners, | engagement |
11.Attach burners to brackets on firebox.
12.Reposition carryover tubes and attach to burners. Replace flame tamers and cooking grates.
Firebox _ii¸
burner Electrode bracket
I
;off electrode with
a flat blade
bracketscrewdriver